GE PFDS450 User Manual download pdf (Page 30)

EXHAUSTING THE DRYER (cont.)

WARNING – NEVER LEAVE THE

BACK OPENING WITHOUT THE PLATE.

(Kit

WE1M454)

Installation Instructions

SIDE VENTING (cont.)

Connect standard metal elbows and ducts to

complete the exhaust system. Cover back opening

with a plate (Kit WE1M454) available from your

local service provider. Place dryer in final location.

ADDING COVER PLATE TO REAR OF CABINET

(SIDE EXHAUST)

ADDING ELBOW AND DUCT FOR EXHAUST TO

LEFT OR RIGHT SIDE OF CABINET (cont.)

Plate

(Kit WE1M454)

• Apply duct tape as

shown on the joint

between the dryer

internal duct and the

elbow, and also the

joint between the

elbow and the side

duct.

CAUTION: Use 4” rigid metal ducting

only inside the dryer. Internal duct joints must be

secured with tape, otherwise they may separate

and cause a safety hazard.

Duct tape

WARNING – BEFORE PERFORMING

THIS EXHAUST INSTALLATION, BE SURE TO

DISCONNECT THE DRYER FROM ITS ELECTRICAL

SUPPLY. PROTECT YOUR HANDS AND ARMS

FROM SHARP EDGES WHEN WORKING INSIDE

THE CABINET. BE SURE TO WEAR GLOVES.

BOTTOM VENTING:

Dryer Exhaust to the bottom of cabinet for

Gas and Electric models.

Remove the screw inside the dryer exhaust duct

and save. Pull the duct out of the dryer. Detach and

remove the bottom knockout.

Remove

screw

and save

Remove desired

knockout (one only)

Fixing hole

Cut the duct as shown and keep portion A.

ø4”

Bottom

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 155 156

Comments to this Manuals

No comments

GE PFDS450 User Manual Page 30

Comments to this Manuals

Related products and manuals for Electric laundry dryers GE PFDS450