GE PFDS450 User Manual download pdf (Page 24)

Installation Instructions

CONNECTING DRYER USING 3-WIRE

CONNECTION

CONNECTING DRYER USING 3-WIRE

CONNECTION (cont.)

WARNING – NEVER LEAVE THE

COVER OFF OF THE TERMINAL BLOCK.

CONNECTING AN ELECTRIC DRYER (cont.)

3-wire Connection

Not for use in Canada.

DO NOT use for Mobile Home Installations.

NOT for use on new construction.

NOT for use on recreational vehicles.

NOT for use in areas where local codes prohibit

grounding through the neutral conduction.

Turn off the circuit breaker(s) (30 amp) or remove

the dryer’s circuit fuse at the electrical box.

Be sure the dryer cord is unplugged from the wall

receptacle.

Remove the power cord cover located at the lower

back.

Install 3/4-in. UL-recognized strain relief to power

cord entry hole. Bring power cord through strain

relief.

Connect power cord as follows:

A. Connect the 2 hot lines to the outer screws of

the terminal block (marked L1 and L2).

B. Connect the neutral (white) line to the center of

the terminal block (marked N).

Be sure ground strap is connected to neutral

(center) terminal of block and to green ground

screw on cabinet rear. Tighten all terminal block

screws (3) securely.

Properly secure power cord to strain relief.

Reinstall the cover.

3 #10 AWG

minimum

copper

conductors or

120/240V 30A

power supply

cord kit marked

for use with

dryers and

provided with

closed loop or

spade terminals

with upturned

ends (not

supplied)

Hot Wire

Green

ground

screw

Neutral

(white)

3/4” UL

Recognized

Strain Relief

Strain

Relief

Bracket

Screw

If required, by local code, install external ground (not

provided) to grounded metal, cold water pipe, or other

established ground determined by a qualified electrician.

Ground

Strap

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 155 156

Comments to this Manuals

No comments

GE PFDS450 User Manual Page 24

Comments to this Manuals

Related products and manuals for Electric laundry dryers GE PFDS450