GE PFDS450 User Manual download pdf (Page 38)

REVERSING THE DOOR SWING (if desired)

REVERSE HINGE AND CAPS (CONT.)

• Assemble the hinge to the opposite side of the

inner door, using 4 screws (#8-32 x 0.50” machine

screws).

• Assemble the new inner door cap (from reversibility

kit) on the opposite side of the hinge, using 2

screws (#8 x 0.75” tapping screws).

• Install the the screws, nuts and washers on the

opposite side of the hinge in the 2 remaining holes.

• Flip the inner door so that the inner part faces down.

Assemble the inner cover (mask), be sure the snaps

have clamped the inner cover. Assemble the outer

window, be sure the 2 snaps have clamped the outer

window.

Replace

4 x E

screws

Replace

2 x D

screws

Inner

door

cap

Replace

2 screws,

2 nuts and

2 washers

Installation Instructions

REASSEMBLE DOOR ASSEMBLY

Turn the inner door over

and place on a soft,

protected flat surface

so that the inner part is

facing down. Assemble

the chrome cover to the

inner door by placing

them together. Flip the

door assembly over and

assemble, using 7 screws

(#10 x 1.125” tapping

screws).

7 x A Screws

REVERSE FRONT PANEL PLUG

BUTTONS AND STRIKE PLATE

Remove the 2 plug buttons on the dryer front

panel, using a putty knife or other flat tool as

shown, and reinstall on the opposite side. Switch

the strike bracket and its cover by removing 2

screws (#8 x 0.625” tapping screws) for each and

reinstalling on opposite sides.

Strike

bracket

2 Plug

buttons

Protective

piece of tape

NOTE: Apply a protective piece of tape to the side

of the plug button where the putty knife blade will

be inserted to prevent scratching.

Outer window

Inner cover

(Mask)

Hinge

Snap

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 155 156

Comments to this Manuals

No comments

GE PFDS450 User Manual Page 38

Comments to this Manuals

Related products and manuals for Electric laundry dryers GE PFDS450