GE PFDS450 User Manual download pdf (Page 21)

Installation Instructions

TEST FOR LEAKS

WARNING – Never use an open

flame to test for gas leaks.

Check all connections for leaks with soapy solution

or equivalent.

Apply a soap solution. The leak test solution must

not contain ammonia, which could cause damage

to the brass fittings.

If leaks are found, close the valve, retighten the joint

and repeat the soap test.

Open Gas

Valve

ELECTRICAL CONNECTION

INFORMATION FOR GAS DRYERS

WARNING – To reduce the risk of

fire, electrical shock and personal injury:

•

Do not use an extension cord or an adapter plug

with this appliance.

•

The dryer must be electrically grounded in

accordance with local codes and ordinances, or

in the absence of local codes, in accordance with

the NATIONAL ELECTRICAL CODE, ANSI/NFPA NO.

70 or Canadian Electrical Code, CSA C22.1

ELECTRICAL REQUIREMENTS FOR GAS

DRYERS

This appliance must be supplied with 120V, 60Hz,

and connected to a properly grounded branch

circuit, protected by a 15- or 20-amp circuit breaker

or time-delay fuse.

If electrical supply provided does not meet the

above specifications, it is recommended that a

licensed electrician install an approved outlet.

WARNING – This dryer is equipped

with a three-prong (grounding) plug for your

protection against shock hazard and should be

plugged directly into a properly grounded

three-prong receptacle. Do not cut or remove the

grounding terminal from this plug.

Ensure proper

ground exists

before use.

If local codes permit, an external ground wire (not

provided), which meets local codes, may be added

by attaching to the green ground screw on the rear

of the dryer, and to an alternate established ground.

Ensure proper ground exists before use.

Ground

Screw

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 155 156

Comments to this Manuals

No comments

GE PFDS450 User Manual Page 21

Comments to this Manuals

Related products and manuals for Electric laundry dryers GE PFDS450