GE PT925 User Manual download pdf (Page 29)

– 29 –

To replace the door:

Firmly grasp both sides of the door at the top.1.

With the door at the same angle as the removal 2.

position, seat the indentation of the hinge arm

into the bottom edge of the hinge slot. The

notch in the hinge arm must be fully seated into

the bottom of the slot.

7. On both sides of the door, press down on the

release buttons on each hinge.

8. Lift the door up until it is clear of the hinge.

Door

Frame

Release buttons

Indentation

Bottom

edge

of slot

Hinge arm

3. Fully open the door. If the door will not fully

open, the indentation is not seated correctly in

the bottom edge of the slot.

4. Push the hinge locks up against the front frame

of the oven to the locked position.

Hinge

lock

Hinge

arm

5. Close the oven door.

Remove the two T15 Torx screws (1 on each 4.

side) from the outer door assembly.

Caution: Care must be taken if reinstalling the door

handle. Overtightening the screws can damage the

handle. Hand-tighten the screws and make sure the

handle ﬁts snugly against the door panel. (Do not

use an electric driver.)

To remove the lower outer door assembly:

Remove the lower door. (See 1.

Door Assemblies.)

Place the inner door assembly, gasket side up, 2.

on a protective surface.

Remove the four T15 Torx screws from the 3.

bottom of the outer door assembly.

Note: The inner door assembly is heavier than the

outer door assembly.

Separate the inner door assembly from the 5.

outer door assembly.

Remove the four 1/4-in. hex-head screws and 6.

brackets that hold the door handle to the outer

door assembly.

Door Shown with Inner Door Assembly Removed

Outer Door Assembly

1 of 2

(Continued next page)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 61 62

Comments to this Manuals

No comments

GE PT925 User Manual Page 29

Comments to this Manuals

Related products and manuals for Cookers GE PT925