GE PT925 User Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 62
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
– 31 –
Assembly Notes
When assembling, make sure the hinges are parallel
to each other and perpendicular to the door liner. If
not, the hinge may bind on the receiving channel of
the door. If the new hinge is not in the cocked and
locked position after installing, place the bottom of
the door against a firm, protected surface and push
the hinge arm down to the cocked position. Pull the
hinge lock back against the door liner surface to
lock the hinge in this position.
Air enters the door assembly through large slots in
the bottom and flows upward between the inner
and outer assemblies, exhausting through slots
in the top of the door. DO NOT INSULATE THIS AIR
CHANNEL.
Door Gasket
The gasket forms a complete seal around the front
edge of the oven liner and the inner door panel. The
door gasket is attached to the inner door panel by
spring clips. When removing the gasket, pull the
ends of the gasket out of the slots at the bottom
of the door. Place a finger under the gasket beside
each clip and pull straight up.
When installing the door gasket, it is helpful to fold
the gasket in half and locate the center clip. Insert
the clip at the top of the door and work your way
around the door.
Make sure the gasket is cross-tucked in the
bottom slots of the inner door panel. Use a small
screwdriver to tuck the loose ends of the gasket into
the slots. The overlap is required to ensure a proper
door seal.
Cross Tuck
To replace the upper inner door assembly:
Remove the upper door assembly. (See 1.
Door
Assemblies.)
2. Remove the four T15 Torx screws (2 on each
side) that attach each door hinge to the inner
door. Carefully turn the door over and remove
both door hinges.
3. Remove the six 1/4-in. hex-head screws that
hold the insulation retainer to the inner door.
Remove the insulation retainer.
4. Remove the insulation and the inner glass
assembly from the inner door.
Inner Glass Assembly
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 61 62

Comments to this Manuals

No comments