GE PT925 User Manual download pdf (Page 35)

– 35 –

Oven Temperature Sensor

The resistance of the temperature sensor is:

1080 • Ω at room temperature

2650 • Ω at clean temperature

To remove the oven temperature sensor:

Remove the main rear access panel. (See 1.

Rear

Access Panels.)

Remove the two 1/4-in. hex-head screws that 2.

attach the sensor to the broiler element bracket.

Disconnect the sensor wiring harness from the 3.

back of the oven.

5. Remove the thirteen 1/4-in. hex-head screws

from the top of the heat shield.

1 of 13

6. Lift up the top heat shield.

Disconnect

(Continued next page)

Broil Element

The broil element will not work if the temperature

probe is plugged in. The broil element terminals are

located behind the main rear access panel.

The broil elements are rated at:

Upper oven broil element (inner) - 1700 watts•

Upper oven broil element (outer) - 1050 watts•

Lower oven broil element (inner) - 2200 watts•

Lower oven broil element (outer) - 750 watts•

To remove the broil element:

Remove the main rear access panel. (See 1.

Rear

Access Panels.)

4. Carefully pull the sensor and sensor wiring

harness from the oven liner.

Note: When reinstalling the sensor, use a small ﬂat-

bladed screwdriver to push and guide the sensor

wire harness into the oven liner.

IMPORTANT: The lower wattage elements use

3/16-in. terminal connections. The higher wattage

elements use 1/4-in. terminal connections.

2. Disconnect the wires from the broil element.

Disconnect

3. Remove the two 1/4-in. hex-head screws that

attach the temperature sensor to the broiler

element bracket.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 61 62

Comments to this Manuals

No comments

GE PT925 User Manual Page 35

Comments to this Manuals

Related products and manuals for Cookers GE PT925