GE PT925 User Manual download pdf (Page 41)

– 41 –

Cooling Fan

The cooling fan is located in a recess in the back of

the oven. It is necessary to remove the oven from

the installation to access the cooling fan.

The fan will begin to operate when the oven is in

any cooking mode. The fan may continue to operate

even after the oven is turned off.

To remove the cooling fan:

Remove the main rear access panel. (See 1.

Rear

Access Panels.)

Disconnect the wire harness and the ground 2.

wire from the cooling fan.

Carefully grasp the assembly and tilt the unit 4.

back, up, and out of the oven frame.

Cooling Fan

Disconnect

3. Remove the four 1/4-in. hex-head screws (2

on each side) that hold the cooling fan to the

control compartment.

Disconnect

Ribbon Cable Assembly

To remove the ribbon cable assembly:

Open or remove the lower door.1.

Release the ribbon cable assembly from the 2.

door. (See

Door Assemblies.)

Remove the secondary rear access panel. (See 3.

Rear Access Panels.)

Disconnect the back of the ribbon cable from 4.

the mating connector.

Disconnect

5. Remove the 4 screws and nuts from the front

end of the ribbon cable housing.

6. Remove the ribbon cable by sliding it out of the

ribbon cable sleeve.

Note: When installing the new ribbon cable, ensure

that the new cable is positioned between the wings

of the ribbon guide located between the oven

cavities.

1 ... 40 41 42 ... 62

No comments

GE PT925 User Manual Page 41