GE PT925 User Manual download pdf (Page 42)

– 42 –

Door Hinge Receivers

To remove the door hinge receivers:

Remove the side access panels. (See 1.

Side Access

Panels.)

Carefully lift the insulation from the outside of 2.

the oven.

Remove the two T20 Torx screws that hold each 3.

hinge receiver to the oven frame.

4. Push the hinge receiver through the opening in

the oven frame and remove from the rear.

Note: Upon reassembly, ensure the displaced

insulation around the oven and components is

returned to its original position.

Meat Probe and Outlet

The meat probe outlet is located on the top of the

oven cavity, near the front. The meat probe outlet is

connected to the electronic oven control. The meat

probe has a resistance value of 30K-50K Ω at room

temperature.

To remove the meat probe outlet:

Open the lower oven door.1.

Remove the two 1/4-in. hex-head screws that 2.

attach the meat probe outlet to the top of the

oven cavity.

3. Pull the outlet and wiring down from the oven

wall.

Note: When replacing the meat probe outlet, cut

the probe wires and splice the new probe using

approved heat-resistant connectors.

Cut Here

Oven Light Assembly

The oven has two light assemblies in each oven

cavity. The light assemblies are located on the top

rear of the oven. The lights come on when the door

is opened or when the oven is in a cooking cycle.

The oven lights do not come on during self-cleaning

or if the Sabbath Feature is set.

Each light assembly consists of a removable light

cover, a light bulb socket, and a light bulb.

To remove an oven light assembly:

Remove the main rear access panel. (See 1.

Rear

Access Panels.)

Remove the three 1/4-in. hex-head screws that 2.

attach the panel securing the lighting assembly

wires to the rear of the oven.

(Continued Next Page)

1 ... 41 42 43 ... 62

Comments to this Manuals

No comments

GE PT925 User Manual Page 42

Comments to this Manuals

Related products and manuals for Cookers GE PT925