GE JM250DFWW Installation Manual download pdf (Page 22)

Care and cleaning of the range.

Be sure the controls are turned to OFF and the surface units are cool before attempting to remove them.

Surface Units

To clean the surface units, turn the control to

the highest setting for a minute. The coils will

burn off any soil.

To remove a surface unit:

To remove the drip pans for cleaning, the

surface units must be removed first.

Lift the surface unit about 1”above the drip

pan and pull it out.

'RQRWOLIWWKHVXUIDFHXQLWPRUHWKDQµ,I\RX

do, it may not lie flat on the drip pan when you

plug it back in.

Repeated lifting of the surface unit more

than 1s above the drip pan can permanently

damage the receptacle.

To replace a surface unit:

Replace the drip pan into the recess in the

cooktop. Make sure the opening in the pan

lines up with the receptacle.

Insert the terminals of the surface unit through

the opening in the drip pan and into the

receptacle.

Guide the surface unit into place so it rests

evenly.

Do not immerse the surface units in liquids of

any kind.

Do not clean the surface units in a dishwasher.

Do not bend the surface unit plug terminals.

Do not attempt to clean, adjust or in any way

repair the plug-in receptacle.

Drip Pans

Remove the surface units. Then lift out the drip

pans.

For best results, clean the drip pans by hand.

Place them in a covered container (or a plastic

bag) with 1/4 cup ammonia to loosen the soil.

Then scrub with a soap-filled scouring pad if

necessary. Rinse with clean water and polish

with a clean soft cloth.

The drip pans may also be cleaned in a

dishwasher.

Clean the area under the drip pans often. Built-

up soil, especially grease, may catch fire.

Do not cover the drip pans with foil. Using foil so

close to the receptacle could cause shock, fire or

damage to the range.

Surface unit

Drip pan

Receptacle

Lift-Up Cooktop

Clean the area under the cooktop often. Built-up

soil, especially grease, may catch fire.

To make cleaning easier, the entire cooktop

may be lifted up and supported in the up

position.

Be sure all the surface units are turned off

before raising the cooktop. The surface units

and drip pans do not need to be removed;

however, you may remove one to make raising

the cooktop easier. A support rod will hold the

cooktop up while you clean underneath it.

After cleaning under the cooktop with hot,

soapy water and a clean cloth, lower the

cooktop. Be careful not to pinch your fingers.

Be sure all surface units are turned

off before raising the cooktop.

Support rod

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

GE JM250DFWW Installation Manual Page 22

Comments to this Manuals

Related products and manuals for Unknown GE JM250DFWW