GE JM250DFWW Installation Manual download pdf (Page 19)

Care and cleaning of the range. GEAppliances.com

Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.

Control Knobs

The control knobs may be removed for easier

cleaning.

Make sure the knobs are in the OFF positions

and pull them straight off the stems for

cleaning.

The knobs can be cleaned in a dishwasher or

they may also be washed with soap and water.

Make sure the insides of the knobs are dry

before replacing.

Replace the knobs in the OFF position to

ensure proper placement.

Control Panel

It’s a good idea to wipe the control panel after

each use. Clean with mild soap and water or

vinegar and water, rinse with clean water and

polish dry with a soft cloth.

Do not use abrasive cleansers, strong liquid

cleansers, plastic scouring pads or oven

FOHDQVHUVRQWKHFRQWUROSDQHO³WKH\ZLOO

damage the finish. A 50/50 solution of vinegar

and hot water works well.

Clear groove

in stem

Molded

rib

How to Remove Protective Shipping Film and Packaging Tape

Carefully grasp a corner of the protective

shipping film with your fingers and slowly peel

it from the appliance surface. Do not use any

sharp items to remove the film. Remove all of

the film before using the appliance for the first

time.

To assure no damage is done to the finish

of the product, the safest way to remove

the adhesive from packaging tape on new

appliances is an application of a household

liquid dishwashing detergent. Apply with a soft

cloth and allow to soak.

NOTE: The adhesive must be removed from all

parts. It cannot be removed if it is baked on.

Porcelain Enamel Cooktop

The porcelain enamel finish is sturdy but

breakable if misused. This finish is acid-

resistant. However, any acidic foods spilled

(such as fruit juices, tomato or vinegar) should

not be permitted to remain on the finish.

If acids spill on the cooktop while it is hot, use

a dry paper towel or cloth to wipe it up right

away. When the surface has cooled, wash with

soap and water. Rinse well.

For other spills such as fat spatterings, wash

with soap and water or cleansing powders

after the surface has cooled. Rinse well. Polish

with a dry cloth.

Oven Vent

The oven is vented through an opening under

the right rear surface unit.

Never cover the opening with aluminum foil or

any other material.

If your range is removed for cleaning, servicing or any

reason, be sure the anti-tip device is reengaged properly

when the range is replaced. Failure to take this precaution could result in tipping of

the range and cause injury.

WARNING

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

GE JM250DFWW Installation Manual Page 19

Comments to this Manuals

Related products and manuals for Unknown GE JM250DFWW