Ge 60-883-95R User Manual download pdf (Page 2)

Notices

FCC Part 15 Information to the User

Changes or modifications not expressly approved by GE Interlogix can void the user’s authority to operate the equipment.

FCC Part 15 Class B

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the affected equipment and the panel receiver to separate outlets, on different branch circuits.

• Consult the dealer or an experienced radio/TV technician for help.

ACTA Part 68

This equipment complies with Part 68 of the FCC Rules. Located on this equipment is a label that contains, among other information, the FCC registration num-

ber and the ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone company.

FCC Part 68 Registration No. B4Z-USA-46042-AL-T

The REN is used to determine the maximum number of devices that may be connected to your telephone line. Excessive RENs on a telephone line may result in

devices not ringing in response to an incoming call. In most areas, the sum of all device RENs should not exceed five (5.0). To be certain of the number of

devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. For products approved after July 23, 2001, the

REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal

point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.

A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and require-

ments as adopted by ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compliant modular

jack that is also compliant. See the Installation Instructions for details.

Alarm dialing equipment must be able to seize the telephone

line and place a call in an emergency situation. It must be

able to do this even if other equipment (telephone, answering

system, computer modem, etc.) already has the telephone line

in use. To do so, alarm dialing equipment must be connected

to a properly installed RJ31X jack that is electrically in series

and ahead of all other equipment attached to the same tele-

phone line. Proper installation is depicted in the following

diagram. If you have any questions concerning these instruc-

tions, consult your local telephone company or a qualified

installer about installing an RJ31X jack and alarm dialing

equipment for you.

If this equipment causes harm to the telephone network, the

telephone company may temporarily disconnect your service.

If possible, you will be notified in advance. When advance

notice is not practical, you will be notified as soon as possi-

ble. You will also be advised of your right to file a complaint

with the FCC.

The telephone company may make changes in its facilities,

equipment, operations, or procedures that could affect the

operation of the equipment. You will be given advance notice

in order to maintain uninterrupted service.

If you experience trouble with this equipment, please contact the company that installed the equipment for service and/or repair information. The telephone com-

pany may ask you to disconnect this equipment from the network until the problem has been corrected or you are sure that the equipment is not malfunctioning.

This equipment may not be used on coin service provided by the telephone company. Connection to party lines is subject to state tariffs.

Patent Information

This product and the use of this product may be covered by one or more of the following patents: 4,864,636, 5,805,063, 5,872,512, 5,942,981, 5,686,896,

5,686,855, 4,855,713. Except as expressly provided herein, the purchase of this product shall not constitute a license or otherwise provide a right to practice a

method covered by any of the identified patents. GE Interlogix hereby grants the purchaser of this product a limited non-exclusive license to practice the methods

patented in the identified patents solely with products manufactured, sold or licensed by GE Interlogix. This license grant does not extend to the use of unli-

censed third party products with this product.

N e t w o r k

S e r v i c e

P r o v i d e r ' s

F a c i l i t i e s

T e l e p h o n e

L i n e

N e t w o r k

D e m a r c a t i o n

P o i n t

T e l e p h o n e

A n s w e r i n g

S y s t e m

F a x M a c h i n e

C o m p u t e r

T e l e p h o n e

A l a r m D i a l i n g

E q u i p m e n t

R J 3 1 X

J a c k

U n u s e d

R J - 1 1 J a c k

U n u s e d

R J - 1 1 J a c k

C u s t o m e r P r e m i s e s E q u i p m e n t a n d W i r i n g

2266 Second Street North

North Saint Paul, MN 55109

Technical Support: (800)-777-2624

GE Interlogix

1 2 3 4 5 6 7 ... 33 34

Comments to this Manuals

No comments

Ge 60-883-95R User Manual Page 2

Comments to this Manuals

Related products and manuals for Safety Ge 60-883-95R