GE JGP985 User Manual download pdf (Page 26)

Installation Instructions

INSTALL THE COOKTOP

PREPARE THE COOKTOP

Remove the vent grille, vent filter, sealed burner

module and the tape from the burner caps.

Turn the cooktop over (upside down) and gently

place it on the styrofoam packing.

Unscrew (loosen) the side hold-down screws.

Install the plenum to the cooktop using 4 screws.

The motor opening on the box goes toward

the left side of the unit (the side with the grease

jar lid).

Use styrofoam

to protect cooktop

Loosen side hold-

down screws

PREPARE THE COOKTOP (cont.)

Remove the 4 nuts and the vent guard from the

blower assembly and set them aside.

Rotate the cooktop and plenum forward and

carefully set it on its back edge on the styrofoam

packing.

Install the blower assembly onto the plenum so

that the blower exhaust is pointing down or back

as needed. Push the bolts through the bolt holes

in the plenum.

From the vent opening in the top of the

cooktop, reinstall the vent guard over the bolts.

Use the 4 nuts to secure the blower assembly and

vent guard to the inside of the plenum.

For back exhaust,

position blower

outlet in direction

of this arrow

For down exhaust,

position blower

outlet in direction

of this arrow

4 Nuts

(3/8″ socket

required)

Vent guard

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 79 80

No comments

GE JGP985 User Manual Page 26