GE JGP985 User Manual download pdf (Page 28)

Installation Instructions

INSTALL THE COOKTOP

ELECTRICAL CONNECTION

Electrical requirements:

120-volt, 60-Hertz, individual, properly grounded

branch circuit protected by a 15-amp circuit

breaker or time-delay fuse.

GROUNDING

IMPORTANT: (Please read carefully.) FOR

PERSONAL SAFETY, THIS APPLIANCE MUST

BE PROPERLY GROUNDED.

The power cord of this appliance is equipped

with a three-prong (grounding) plug which mates

with a standard three-prong grounding wall

receptacle to minimize the possibility of electric

shock hazard from this appliance. The customer

should have the wall receptacle and circuit

checked by a qualified electrician to make sure

the receptacle is properly grounded and has

correct polarity.

Where a standard two-prong wall receptacle is

encountered, it is the personal responsibility and

obligation of the customer to have it replaced

with a properly grounded three-prong wall

receptacle in accordance with the National

Electrical Code.

Do Not, Under Any Circumstances, Cut Or

Remove The Third (Ground) Prong From The

Power Cord.

Do not use an extension cord with this appliance.

Plug the power cord into an approved wall outlet.

INSTALL THE COOKTOP

Lower the cooktop into the countertop opening,

guiding it into position.

SECURE THE COOKTOP

Tighten the tie-down bolts to secure the cooktop

to the counter. For countertops less than 1″ thick,

securely attach filler blocks of wood to the

bottom of the countertop where the tie-down

bolts will be tightened.

Countertop

Filler wood block

for countertops

less than 1″ thick

Tie-down

bolt through

cooktop tab

OPTIONAL: ATTACH A BLOWER

TRANSITION DUCT

If using 6″ round standard ductwork, attach a

blower transition duct. This 3

⁄4″ x 10″ rectangle

to 6″ round transition duct is available at your

local building supply store.

Install the transition duct to the blower outlet.

Secure all joints with duct tape to assure an

airtight seal.

Screw

(on other side)

Screws

CONNECT THE DUCTWORK

Connect the ductwork prepared earlier to the

blower transition duct.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

Comments to this Manuals

No comments

GE JGP985 User Manual Page 28

Comments to this Manuals

Related products and manuals for Barbecues & grills GE JGP985