GE JGP985 User Manual download pdf (Page 15)

Control Knobs and Control Panel Seal

After grilling there may be soot on the

knobs and control panel seal. This soot

can be removed by scrubbing with a

plastic scrubber and mild dishwashing

detergent. The control knobs may

be removed for cleaning.

To remove a knob, pull it straight up.

Wash the knobs in soap and water but

do not soak. Avoid getting water down

into the knob stem holes.

Wipe with a sponge, damp cloth or

paper towel. Do not scrub with steel

wool pads or abrasive cleansers.

To replace a knob, match the flat part

of the knob opening with the flat side

of the shaft.

Care and cleaning of the cooktop. www.GEAppliances.com

Before Cleaning

Before cleaning any part of your

cooktop, be sure all controls are off

and DISCONNECT ELECTRICAL POWER

TO THE COOKTOP at the fuse box or

circuit breaker panel, or pull the

cooktop power plug, located beneath

the cooktop and inside the cabinets.

Do not operate the cooktop without all

parts in place.

Grease Jar

A grease jar is located below the grill

basin pan under the countertop. Check

periodically to prevent spillovers.

Unscrew and remove.

If the jar is broken, replace with any

heat tempered jar, such as a canning

jar, that has a wide mouth screw neck.

Porcelain Cooktop

The porcelain enamel finish is sturdy

but breakable if misused. This finish is

acid-resistant. However, any acidic foods

spilled (such as fruit juices, tomato or

vinegar) should not be permitted to

remain on the finish.

If acids spill on the cooktop while it is

hot, use a dry paper towel to wipe it

up right away. When the surface has

cooled, wash with soap and water or

cleansing powders. Rinse well.

For other spills, such as fat spatterings,

wash with soap and water or cleansing

powders after the surface has cooled.

Rinse well. Polish with a dry cloth.

Stainless Steel Surfaces

Do not use a steel wool pad; it will scratch

the surface.

1. Shake bottle well.

2. Place a small amount of CERAMA

BRYTE

®

Stainless Steel Cleaner on a

damp cloth or damp paper towel.

3. Clean a small area (approximately

8″ x 8″), rubbing with the grain of

the stainless steel if applicable.

4. Dry and buff with a clean, dry paper

towel or soft cloth.

5. Repeat as necessary.

NOTE: If a mineral oil-based stainless steel

appliance cleaner has been used before to clean

the appliance, wash the surface with dish soap

and water prior to using the CERAMA BRYTE

®

Stainless Steel Appliance Cleaner. After washing

the surface with dish soap and water, use a

generous amount of CERAMA BRYTE

®

Stainless

Steel Appliance Cleaner to clean the appliance.

To Order

To order CERAMA BRYTE

®

Stainless

Steel Appliance Cleaner, please call our

toll-free number:

National Parts Center 800.626.2002

www.GEAppliances.com

CERAMA BRYTE

®

Stainless Steel Appliance

Cleaner . . . . . . . . . . . . . . . . . . . .# PM10X311

Safety Instructions

Operating Instructions Care and Cleaning

Troubleshooting Tips Consumer Support

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 79 80

Comments to this Manuals

No comments