GE Simon Security System User Manual download pdf (Page 31)

Simon Security System 23

3. Press Add from the Start menu. Panel announces, Select from main menu.

4. Press Option #. Panel announces, Option 1, press again for next option or done to

select.

5. Press 82. Panel announces, Option 82, press again for next option or use num-

bered keys to enter option.

6. Enter the temperature (51 - 91) with the numbered keys.

7. Panel announces the temperature that has been selected.

Delete deletes the Cooling Set Point feature.

1. Open panel cover. Panel announces, Use numbered keys to enter ID.

2. Enter Master Code using the numbered keys. Panel announces, Please select from

Start Menu.

3. Press Delete from the Start menu. Panel announces, Select from main menu.

4. Press Option #. Panel announces, Option 1, press again for next option or done to

select.

5. Press 82. Panel announces, Option 82, press again for next option or done to

delete.

6. Press DONE. Panel announces, Option 82 deleted.

Trouble Beeps Your security system is able to automatically test itself for:

• Power failures

• Low batteries

• Non-working sensors

• Communication troubles with the Central Monitoring Station

When your security system detects one of the problems above, six rapid beeps sound

every minute, until the trouble condition is corrected.

AC Power Failure

This condition occurs if your security system has been accidentally unplugged or if

there has been an AC power outage. The backup battery will take over. If AC power is

not restored within 15 seconds, the panel will go dark and alert you with trouble beeps.

If you press any button, the display will light and pressing SYSTEM STATUS will

confirm the AC power failure. If AC power is not restored within a programmed

period of time (5-254 minutes) the system will call the central monitoring station (if

programmed by installer). The backup battery, if fully charged, will last for 18 - 24

hours, depending on the load applied to the panel, with no AC power.

System Battery Failure

This condition occurs if the emergency backup battery has failed. Status beeps will

start and the SYSTEM STATUS button will light. Press the SYSTEM STATUS but-

ton to hear the trouble message. If your AC power is not working, your security sys-

tem will shut down once the battery has failed. If the condition does not clear after AC

power has been restored and 24 hours have passed, call your security system dealer.

Restoration of Power

This condition occurs after a complete loss of power (AC and battery). When power is

restored, the panel will return to the arming state with the same zones bypassed it had

prior to losing power.

Silencing Trouble Beeps

To stop the trouble beeps, press the SYSTEM STATUS button or arm/disarm the sys-

tem while the trouble condition exists. Trouble beeps will begin 4 hours later, unless

the trouble condition is corrected.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 39 40

Comments to this Manuals

No comments

GE Simon Security System User Manual Page 31

Comments to this Manuals

Related products and manuals for Security access control systems GE Simon Security System