GE Simon Security System User Manual download pdf (Page 13)

Simon Security System 5

Note

This feature is most likely

used when there is no one

on the premises.

Panel announces, Motions on. Arm Motion Sensors light will be lit and the exit delay

will begin.

¾

Activate Latchkey Feature

1. Press the Arm Motion Sensors button twice.

2. Enter Access Code (if needed).

Panel announces, Motions on, Latchkey on. Arm Motion Sensors light will blink and

the exit delay will begin.

¾

Disarming Your System

1. Upon reentering your home the entry delay will begin.

2. Status beeps will sound.

3. Enter your access code using the Code buttons.

Panel announces, System disarmed and the Disarm light will be lit.

¾

Subdisarm Your System

1. Enter your Master Access Code while the system is disarmed.

Panel announces, System disarmed. Disarm button light blinks and the system is sub-

disarmed. When you’ve finished accessing the protected areas, press the Disarm but-

ton again. Panel announces, System disarmed. Disarm button light stops blinking.

System is in Disarm mode.

If You Never Leave After Arming

Your panel can be programmed to recognize that you never left the premises. If you

press the Arm Doors & Windows button and the Arm Motion Sensors button but

don’t exit before the exit delay expires, the panel will not arm the motion sensors.

Check with your installer to find out if this feature is enabled for your panel.

If You Forgot Something After Arming

Your panel can be programmed to recognize when you leave the premises then quickly

reenter. The panel will restart the exit delay to give you time to collect your things and

leave again. You must leave before the exit delay expires or disarm the system. Ask

your installer if this feature is enabled for your system.

Arming When the Panel Battery is Low

Your panel may be programmed so that you cannot arm the system if the panel battery

is low. Ask your installer if this feature is enabled for your system.

CODE

Note

40 keypresses for invalid

codes (i.e. 10 invalid 4-digit

codes) will cause a system

access alarm. The alarm

locks all touchpads, except

keychains, for 90 seconds.

There are 5 CODE buttons located in the second row of the panel. Each button repre-

sents 2 numbers. The left CODE button is 1/2, which means that this button is pressed

when entering either 1 or 2. For example, if your access code is 1-2-3-4 you must press

the 1/2 button twice and the 3/4 button twice to enter that access code. Access code

lengths need to be between 3 and 6 digits and are set by the installer.

If you enter you home and you hear alarm sirens, or if controlled lights that

should be off are on, an intruder may be inside or another emergency may

have occurred. Leave immediately and call for help.

Warning

C O D E

9 / 05 / 6 7 / 81 / 2 3 / 4

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments

GE Simon Security System User Manual Page 13

Comments to this Manuals

Related products and manuals for Security access control systems GE Simon Security System