GE Simon Security System User Manual download pdf (Page 32)

Simon Security System

Sensor Failure

This condition occurs if a sensor is not communicating with the panel. Status beeps will

start and the SYSTEM STATUS button will light. Press the SYSTEM STATUS button

to hear which sensor(s) failed. Perform sensor tests. It may be necessary for you to call

your security system dealer if the problem continues.

Sensor Low Battery

This condition occurs if a system sensor has a low battery. The sensor may still be com-

municating with the panel. Status beeps will start and the SYSTEM STATUS button

will light. Press the SYSTEM STATUS button to hear which sensor has a low battery.

It may be necessary for you to call your security system dealer to resolve this problem.

Some sensor batteries can be replaced by the homeowner.

Fail-To-Communicate

This condition occurs if your security system cannot communicate to the central moni-

toring station. Your system will try to report to the central monitoring station 8 times

before it tells you there is a Fail-To-Communicate problem. Status beeps will start and

the System Status button will light. Press the System Status button to hear the trouble

message. It may be necessary for you to call your security system dealer if the problem

continues.

Sensor Open

This condition occurs if a door or window is open, a system sensor has been disturbed

and not reset properly. For example, a Door/Window Sensor magnet may have been

removed from the sensor. Your system will indicate this condition to you by causing the

System Status button to light. When you press this button, the system responds with

Sensor # Name open. Correct the problem by resetting the sensor. If this condition con-

tinues, call your security system dealer

Sensor Tampered

This condition occurs when a sensor is physically tampered with. If the system is armed

an alarm will occur. For example, the cover is taken off of one of the sensors. Your sys-

tem will indicate this condition to you by causing the System Status button to light.

When you press this button, the system responds with, Sensor # Name tampered. Cor-

rect the problem by resetting the sensor. If this condition continues, call your security

system dealer.

Option 50 Detected

The panel receiver may be experiencing some interference. The system will call to

notify the central monitoring station about this problem.

Siren 1 or 2 Failure

Call your security system dealer.

System Access Alarm

The panel cover was opened while the system was armed. The system will call the cen-

tral monitoring station to report a tamper alarm.

Clearing System Status

Press the SYSTEM STATUS button, listen to the status message, then disarm the

system to clear system status. If the trouble condition was a low system battery, per-

form a sensor test. The SYSTEM STATUS button should turn off if all trouble condi-

tions have been corrected.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments

GE Simon Security System User Manual Page 32

Comments to this Manuals

Related products and manuals for Security access control systems GE Simon Security System