GE Simon Security System User Manual download pdf (Page 19)

Simon Security System 11

How to Use an

Off-Site Phone

You may use an off-site phone to arm/disarm your panel, turn lights on and off, check

system status, or conduct an audio session (ask your installer if you have this feature).

¾

How to gain access to the Control Panel:

Note

You may have to perform

steps 1 & 2 more than once.

Ask your installer how your

system is programmed.

1. Call the panel phone number and let the phone ring once then hang up.

2. Wait 10 - 40 seconds and call the panel again.

3. The panel should answer on the first ring. The panel will announce “System On”.

4. Press the * button on your telephone and you will hear “System Activated”.

At this point you may perform the actions listed in the following table of phone com-

mands. CODE refers to the master and access codes programmed into your system.

If you are interactive with your panel and the panel hangs up on you, the system is

calling in a report to the central monitoring station, pager or remote phone due to an

action made by you or someone at the security system site.

Using

Touchpads and

Keypads

Touchpads and keypads are used to control the security system from any location

within or near your home.

Touchpads and Keypads

Interfacing with the system using a Remote Handheld Touchpad and Dialog QS1500

Touchtalk Interactive Keypad is similar to using the panel.

System Status

Press System Status once to hear information about your system from the panel. See

“Status Beeps”.

ARM Doors & Windows

Press Arm Doors & Windows button once to turn the security system protection on

for all protected doors and windows.

Phone Commands

Panel Function Phone Command

DISARM ‚ + CODE + 1

ARM Doors/Windows ‚ + CODE + 2

ARM Doors/Windows with No Entry Delay ‚ + CODE + 2 + 2

ARM Motions ‚ + CODE + 3

ARM Motions with Latchkey ‚ + CODE + 3 + 3

ARM Doors/Windows and Motions ‚ + CODE + 2 + 3

ARM Doors/Windows with No Entry Delay

and Motions with Latchkey

‚ + CODE + 2 + 2 + 3 + 3

Lights On/Off ‚ + CODE + 0

System Status ‚ + CODE + # + 1

AVM

Note

Phone commands cannot be used when the

panel is in AVM mode.

‚ + CODE + 5 + X (X = a command

from the Audio Verification Set, 1=Talk,

2=VOX, 3=Listen)

Hang Up ‚ + CODE + 9 (Phone Command Mode)

‚ + 99 (AVM Mode)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Comments to this Manuals

No comments

GE Simon Security System User Manual Page 19

Comments to this Manuals

Related products and manuals for Security access control systems GE Simon Security System