GE General Electric Computer Monitor LTC-MAP 2130 User Manual download pdf (Page 43)

Section 3: Installation 3-19

70055MP Revision D February 3, 2000

Wiring the Internal Heater

The monitor’s internal heater requires 110 VAC power input. Refer to Figure

3-9 for Heater Terminal locations.

WARNING: Do not bridge the heater power terminals to the monitor power

supply terminals if DC is used to supply the monitor. The heater is AC only.

Wiring Power

The LTC-MAP 2130 is factory configured for either 120 VAC or 240 VAC

operation per the customer order. Refer to Figure 3-9 for the location of the

Power Input Terminals.

1. Connect the “hot” phase of the 120 or 210 power line to the LINE Power

Input Terminal.

2. Connect the neutral line to the NEUT Power Input Terminal.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 67 68

No comments

GE General Electric Computer Monitor LTC-MAP 2130 User Manual Page 43