GE General Electric Computer Monitor LTC-MAP 2130 User Manual download pdf (Page 34)

3-10 Section 3: Installation

February 3, 2000 70055MP Revision D

Wiring the Sensors

Refer to Table 1-1 for a list of sensors available for use with the

LTC-MAP 2130 Monitor. Detailed installation information for each sensor is

provided in the referenced documentation.

Some general notes to consider during sensor selection and installation:

• Thermowell RTD sensors require a signal conditioning transmitter to

provide a 4-20 mA output to the monitor.

• Figure 3-4 provides Sensor and Input Connection locations on the I/O

board.

• We recommend using #18 AWG shielded, twisted pair wire for sensor

input connections to the I/O board, unless stated otherwise in the

documentation provided with the sensor. Use of shielded twisted pair

improves noise immunity; the shield should be grounded at one end

only.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

No comments

GE General Electric Computer Monitor LTC-MAP 2130 User Manual Page 34