GE IM4A User Manual download pdf (Page 34)

Installation Instructions

BEFORE YOU BEGIN

Read each step thoroughly before proceeding.

•

CAUTION – Unplug the

Refrigerator. To eliminate the danger

of electric shock during installation,

you must unplug the refrigerator from

its electrical outlet.

Flat blade and Phillips

screwdrivers

Pliers

TOOLS YOU WILL NEED

Sharp knife

INSTALL FILL TUBE

• Slide the fill tube shipped

with the refrigerator onto the

water tube inlet (12). If the fill

tube has been misplaced, call

1.800.626.2002 and order part

WR02X11712.

• Go to the back of the refrigerator.

Remove the label covering the

hole. Pull out the insulation plug

and any debris.

• On the tube side of the water tube

inlet (12), there is an adhesive

backing. Remove the adhesive

backing and slide the tube into the

hole at the back of the refrigerator.

Firmly press on the inlet to secure

it to the refrigerator.

PREPARE FOR INSTALLATION (cont.)

• Inside the freezer, remove the two small white

plug buttons (on some models) from the side

wall. (If screws are present instead of plugs,

leave them in place.)

• Remove and discard

the large white plug

from the rear freezer

wall. Pull out the gray

insulation plug and

remove any debris.

• Remove the outlet

cover with a flat-blade

screwdriver.

Power

Switch

SET POWER SWITCH TO O (off)

Set the icemaker power switch to O (off). Leave

the power switch in the O (off) position until the

refrigerator is connected to the water supply to

prevent premature operation.

Outlet

cover

Remove side wall plug

buttons or leave screws

in place

Rear wall

plug button

Insulation

plug

PREPARE FOR INSTALLATION

• Remove the storage

basket (on some models)

by pulling it out to the

stop position and lifting

it up and out.

Note: After removing

the basket, push the

extension arms back

into the freezer

compartment.

• Remove the chiller shelf

(on some models) by

pulling it straight out.

• Remove the ice bucket

by pulling it out and

lifting it up and out.

• Remove the center

vertical shelf support

(on some models) by

lifting it and rotating

its bottom to the right.

ICEMAKER INSTALLATION INSTRUCTIONS S

Are these the right instructions for your model? Follow the Installation Instructions indicated by

the label on the back of the refrigerator— or

SRQPNML

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 135 136

Comments to this Manuals

No comments

GE IM4A User Manual Page 34

Comments to this Manuals

Related products and manuals for Fridges GE IM4A