GE IM4A User Manual download pdf (Page 41)

Installation Instructions

CONNECT THE TUBING TO THE

REFRIGERATOR

(CONT.)

Place the compression nut and ferrule (sleeve)

onto the end of the tubing as shown. On GE

SmartConnect

™

Refrigerator Tubing kit,

the nuts are already assembled to the tubing.

Insert the end of the tubing into the water valve

connection as far as possible. While holding the

tubing, tighten the fitting.

For plastic tubing from a GE SmartConnect

Refrigerator Tubing kit, insert the molded end

of the tubing into the refrigerator connection

and tighten compression nut until it is hand tight,

then tighten one additional turn with a wrench.

Overtightening may cause leaks.

Fasten the tubing into the clamp provided to hold

it in a vertical position. You may need to pry open

the clamp.

Tubing

Clamp

1/4″

Compression

Nut

SmartConnect

™

Tubing

Refrigerator

Connection

1/4″ Tubing

Tighten any connections that leak.

Reattach the compressor compartment

access cover.

TURN THE WATER ON AT THE

SHUTOFF VALVE

Arrange the coil of tubing so that it does not

vibrate against the back of the refrigerator or

against the wall. Push the refrigerator back to

the wall.

PLUG IN THE REFRIGERATOR

START THE ICEMAKER

Set the icemaker power switch to the I (on)

position. The icemaker will not begin to operate

until it reaches its operating temperature of 15°F

(–9°C) or below. It will then begin operation

automatically if the icemaker power switch is

in the I (on) position.

NOTE: In lower water pressure conditions, the

water valve may turn on up to 3 times to deliver

enough water to the icemaker.

Ferrule

(sleeve)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 135 136

Comments to this Manuals

No comments

GE IM4A User Manual Page 41

Comments to this Manuals

Related products and manuals for Fridges GE IM4A