GE IM4A User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 136
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14
CUT FILL TUBE
If the refrigerator already has a water tube and
inlet assembly on the back of the refrigerator,
go to Step 5.
Cut the fill tube (13) to the length (refer to
the templates on page 42) with a sharp knife
or a single-edge razor blade.
M
M
3
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS M
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator--- or
SRQPNML
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION – Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
REMOVE THE WHITE PLUG
AND OUTLET COVER
Remove the outlet cover with a flat-blade
screwdriver located either on the left or back
freezer wall near the top.
Remove and discard the white plug from the
upper left hand corner of the freezer wall.
2
REPOSITION FREEZER SHELF
For models with two temperature controls
(refrigerator and freezer) only:
Make sure the freezer shelf is in the lowest
position.
1
Remove
plug
13
INSTALL FILL TUBE
Slide the fill tube (13) onto
the water tube inlet (12).
Go to the back of the
refrigerator. Find the small
label or plug button
(depending on model) and
remove it. On the tube side of
the water tube inlet (12), there
is an adhesive backing. Remove
the adhesive backing and slide
the tube into the hole near the top at the back of
the refrigerator. Firmly press on the inlet to secure
it to the refrigerator.
4
12
13
PREPARE FOR INSTALLATION
Inside the freezer, loosen the two mounting screws
(B) but do not screw them all the way out. If your
model does not have the screws already in the
freezer wall, look for two plug buttons. Remove the
plug buttons and insert the two Phillips head screws
(11). The screws should extend approximately
1/2 (13 mm) out from the freezer wall.
5
B
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 135 136

Comments to this Manuals

No comments