GE JVM2052 User Manual download pdf (Page 13)

Installation Instructions

MOUNT THE MICROWAVE OVEN

ATTACH EXHAUST DAMPER

USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws, a hole

large enough for the power cord to fit through, and

a cutout large enough for the exhaust adaptor.

CAUTION: To avoid the risk of personal

injury (back injury or other injuries due to excessive

weight of the microwave oven) or property damage,

you will need two people to install this microwave

oven.

IMPORTANT: Do not grip or use handle during

installation.

WARNING: Risk of Electric Shock. Can

cause injury or death: If installing unit with metal

countertops, cover the edge of the power supply

cord hole with the power supply cord bushing.

IMPORTANT: If filler blocks are not used, case damage

may occur from overtightening screws.

Insert a self-aligning screw through top-center

cabinet hole. Temporarily secure the oven by

turning the screw at least two full turns after

the threads have engaged. (It will be completely

tightened later.)

NOTE: When mounting

the microwave oven,

thread power cord through

hole in bottom of top

cabinet. Keep it tight

throughout Steps 1–3. Do

not pinch cord or lift oven

by pulling cord.

Lift microwave oven,

tilt it forward, and hook

slots at back bottom

edge onto four lower

tabs of mounting plate.

• Read the instructions on the TOP CABINET TEMPLATE.

• Tape it underneath the top cabinet.

• Drill the holes, following the instructions on the TOP

CABINET TEMPLATE.

CAUTION: Wear safety goggles when

drilling holes in the cabinet bottom.

• Place the microwave oven in its upright position, with

the top of the unit facing up.

• This microwave oven is shipped assembled for top

exhaust.

• Attach the exhaust adapter to the blower plate by

sliding it into the guide.

• You will need to make adjustments to ensure proper

alignment with your house exhaust duct after the

microwave oven is installed.

Rotate front of oven up

against cabinet bottom.

Back plate

Blower unit

mounting screw

(2 screws)

Blower plate

mounting screw

(3 screws)

Blower plate

Blower unit

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments

GE JVM2052 User Manual Page 13

Comments to this Manuals

Related products and manuals for Ovens GE JVM2052