GE JTP20 User Manual

130” Built-In Wall OvenInstallationInstructionsJTP20, JTP25, JTP28, JTP48, JTP50, JT912,JT915, JT952, JT955, ZET938, ZET958If you have questions, call

10(Continued on following page)WARNING: Mountingscrews must be used. Failure todo so could result in the ovenfalling out of the cabinet causingserious

11a. With oven installed, take the bottom trimand center it on the bottom front edge ofthe cabinet opening.b. Using the trimas a template,mark the cen

12Lift the oven door byplacing one hand oneach side. The door isheavy, so you may needhelp. Do not lift the doorby the handle.With the door at the sam

13Installation InstructionsRemove all protective film, if present,and any stickers.Check to be sure that all wiring issecure and not pinched or in con

14NOTES

15NOTES

16NOTES

2ElectricalRequirementsThis appliance must be supplied with theproper voltage and frequency, and connectedto an individual, properly grounded branchci

3Open oven door and remove literaturepack, broiler pan and grid, and ovenracks.Remove Installation Instructions fromliterature pack and read them care

4Place the oven on a table or platformeven with the cutout opening.(Platform must support 150 lbs. single,275 lbs. double.)Installation InstructionsPr

5Cabinet Width 30”RecommendedMinimumCutout Locationfrom Floor 32 1/2”Cutout Depth 23 1/2” Min.Cutout Width 28 1/2” Min.28 5/8” Max.Cutout Height 27 1/

6Installation InstructionsCabinet Width 30”RecommendedMinimumCutout Locationfrom Floor 12”Cutout Depth 23 1/2” Min.Cutout Width 28 1/2” Min.28 5/8” Ma

7Installation InstructionsCutout for Single Built-In OvenUnder CounterNOTE: This oven is not approved to beinstalled under a solid disk, inductionor d

8(Continued on following page)Installation InstructionsElectrical ConnectionsATTENTION INSTALLERAll electric wall ovens must be hard wired(direct wire

9Installation InstructionsElectrical Connections cont.B4Three-Conductor BranchCircuit ConnectionWhen connecting to a three-conductor branchcircuit, if