GE PT925DNBB Instruction Manual

Browse online or download Instruction Manual for Ovens GE PT925DNBB. GE PT925DNBB Instructions / Assembly User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
1
Single Double Wall Oven
Installation
Instructions
Before You Begin
Read these instructions carefully and completely.
IMPORTANT—Save these
instructions for local inspector’s use.
IMPORTANT—Observe all
governing codes and ordinances.
Note to Installer—Be sure to leave these
instructions with the consumer.
Note to Consumer—Keep these
instructions for future reference.
Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
NOTE—This appliance must be properly
grounded.
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction box.
A plug and receptacle is NOT permitted on
these products.
Tools Needed
1/8” (3 mm) Drill Bit and
Electric or Hand Drill
Nut Driver 7/16”
(11 mm)
Materials Needed
Strain Relief Clamp for
1/2” conduit
Junction Box
Wire Nuts
String 72”
(183 cm)
31-10696 07-08 JR
Parts Included
(Appearance will vary)
Screws For Installation
(8-18 x .625 Black Dome
Phillips Head)
Lower Oven
Rack Supports
with Hex Nuts
PT925
30” (76.2 cm)
Metal Bottom Trim Assembly
Hex Nuts
If you have questions, call 1.800.GE.CARES or visit our website at: ge.com
Wire Strippers
Phillips #2
Screwdriver
Page view 0
1 2 3 4 5 6 ... 27 28

Summary of Contents

Page 1 - Instructions

1Single Double Wall Oven Installation InstructionsBefore You BeginRead these instructions carefully and completely.• IMPORTANT—Save these instruction

Page 2

10Installation InstructionsSecuring the Oven in the OpeningSliding the Oven Into the Openinga. Loop (do not tie) a 72” (183 cm) string around the cond

Page 3

11Installation InstructionsInstalling the Lower Oven Rack Supports and Oven RacksC4Oven Rack SupportsPlace the rack support with slotted holes over th

Page 4

12Installation InstructionsRemove all protective fi lm, if present, and any stickers.Check to be sure that all wiring is secure and not pinched or in c

Page 5

13DO NOT LIFT THE DOOR BY THE HANDLE!Place hands on both sides of the door, and close the oven door to the removal position, which is most of the way

Page 7

1Horno de pared simple doble Instrucciones de instalaciónAntes de empezarLea estas instrucciones cuidadosa y completamente.IMPORTANTE—Guarde estas

Page 8

2Requisitos eléctricosLa placa de potencia se encuentra en la moldura lateral del horno, el marco lateral frontal del horno o el marco frontal inferio

Page 9

3Abra la puerta del horno y extraiga el paquete de instrucciones y las parrillas del horno.Extraiga las instrucciones de instalación del paquete y lé

Page 10 - Installation Instructions

4Instrucciones de instalación de 30” (76,2 cm) solamenteAAncho del gabinete 30” (76,2 cm)Ubicación recomenda

Page 11

5NOTA: Este horno está aprobado modelos específicos indicados en esta unidad.Instrucciones de instalación

Page 12

2Electrical RequirementsRating plate is located on oven side trim, side front frame or lower front frame.We recommend you have the electrical wiring a

Page 13 - Appendix

6NOTA: Puede necesitarse una separación adicional entre las aberturas. Verifique para asegurarse de que los apoyos del horno por encima de la ubicac

Page 14

7NOTA: El carril del medio que separa las dos aberturas pueden necesitar ser más grande que el de 2” (5,1 cm) mínimo que se muestra. Siempre consulte

Page 15 - Instrucciones

8Instrucciones de instalaciónTodos los hornos eléctricos de pared deben 

Page 16 - Instrucciones de instalación

9Instrucciones de instalación de tres conductoresCuando conecte un circuito ramal de 3 conductores, si los códigos local

Page 17

10Instrucciones de instalaciónPosición firme del horno en la aberturainterior de la aberturaa. Coloque (sin atar) una cuer

Page 18

11Instrucciones de instalaciónhorno del horno inferior horn

Page 19

12Instrucciones de instalaciónRetire cualquier cinta de protección y eti-queta que todavía esté presente.Revise para asegurarse de que todos los alam

Page 20 - Gabinetes

13Coloque las manos en ambos lados de la puerta y cierre la puerta del horno hasta la posición de remoción, que es

Page 21

14Notas

Page 22

3Open oven door and remove literature pack and oven racks.Remove Installation Instructions from literature pack and read them carefully before you beg

Page 23

4Installation InstructionsCutout for 30” (76.2 cm) Single Double Wall OvenACabinet Width 30” (76.2 cm)Recommended Cutout Location from Floor

Page 24

5NOTE: This oven is only approved to be installed under the specifi c models as labeled on this unit.Installation InstructionsCutout for 30” (76.2 cm)

Page 25

6NOTE: Additional clearances between cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the

Page 26

7NOTE: The middle rail separating the two openings may need to be larger than the 2” (5.1 cm) minimum shown. Always refer to the individual installati

Page 27 - Apéndice

8Installation InstructionsElectrical ConnectionsATTENTION INSTALLERAll electric wall ovens must be hard wired (direct wired) into an approved junction

Page 28

9Installation InstructionsB4Three-Conductor Branch Circuit ConnectionWhen connecting to a three-conductor branch circuit, if local codes permit:a. Con

Comments to this Manuals

No comments