GE DPGT750EC/GC User Manual download pdf (Page 33)

– 33 –

6. Slide the gas valve assembly out through the

front of the dryer cavity.

7. Remove the 3 Phillips head screws that

secure the gas valve to the mounting

assembly. Remove the gas valve.

Ignitor

The ignitor is located at the end of the gas valve

assembly in the combustion chamber opening.

Resistance across the ignitor is approximately

300 to 500 Ω.

Screw

Ignitor

Combustion Chamber

Gas Valve Assembly

To remove the ignitor:

1. Shut off the gas and electricity to the dryer.

2. Remove the

Top Cover, Front Panel, and Drum.

3. Using a short Phillips screwdriver, remove the

screw that holds the ignitor to the assembly.

Remove the ignitor.

Note: There is a cutout on the edge of the

combustion chamber to allow access to the

screw.

• The control operates the gas valves by

supplying voltage based on varying duty

cycles.

• It is difficult to determine specific voltages at

the valve due to software algorithms based on

clothes load and temperature settings. The

most accurate diagnostic check is to measure

resistance of the solenoid coils.

To remove the gas valve:

1. Shut off the gas and electricity to the dryer.

2. Remove the

Top Cover, and Front Panel.

3. Disconnect all wiring to the gas valve and

ignitor.

4. Remove the 2 Phillips head screws that hold

the gas valve to the elbow coupling.

5. Remove the 2 Phillips screws that hold the

gas valve assembly to the dryer base.

Elbow Coupling

Dryer Floor

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 62 63

Comments to this Manuals

No comments

GE DPGT750EC/GC User Manual Page 33

Comments to this Manuals

Related products and manuals for Electric laundry dryers GE DPGT750EC/GC