GE DPGT750EC/GC User Manual download pdf (Page 30)

– 30 –

• The inlet thermistor measures the incoming

air temperature and responds to temperature

changes.

• The inlet thermistor provides temperature

change information to the electronic control

board.

• The electronic control board makes heating

and blower decisions based on this

information.

• At room temperature the inlet thermistor has a

resistance value of 2.27 K Ω +/- 5%.

To remove the thermistor:

1. Remove the inlet thermistor access cover

located on the back of the dryer.

2. Disconnect the thermistor wiring.

Inlet Safety Thermostat

The inlet safety thermostat is located on the left

side of the heater housing on electric models and

on the lower, left side of the combustion chamber

on gas models.

Gas Model Location

Electric Model Location

3. Remove the screw that holds the thermistor in

place. Remove the thermistor.

Disconnect

Screw

Manual Reset

Inlet Thermistor

The inlet thermistor is located on the inside of the

inlet air duct on both electric and gas models.

Inlet Thermistor

Manual Reset

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 62 63

No comments

GE DPGT750EC/GC User Manual Page 30