GE DPGT750EC/GC User Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 63
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
– 26 –
To install the drive belt:
1. Place the belt in position around the front of
the drum.
2. Reach under the left side of the drum and
place the belt in position around the motor
pulley. Push the idler pulley to the left and
place the belt onto the idler pulley.
3. Release the idler pulley and guide the belt into
position.
4. Install the
Drum support.
Note: Lift the drum slightly to line up the drum
with the drum support.
5. Check to make sure the belt is in place and
not twisted before installing the top and front
panels.
Belt Switch
The belt switch is fastened to the motor bracket
by 2 Phillips head screws.
The belt switch is activated by the idler pulley.
If the drive belt breaks, the belt switch opens
the drive motor circuit, interrupting all dryer
functions except the drum lamp.
Drum Light
The drum light has a screw-in 15-watt, 120-VAC
bulb located in the top of the front panel. It is
switched on the neutral side by the door switch.
Replace only with a bulb of the same size and
type. (The bulb can be found at most local
stores).
Remove the screw in the bulb lens to access
the bulb.
Drive Belt
The drive belt extends from the motor pulley, past
the idler pulley, and around the perimeter of the
dryer drum. Part # WE12X10011.
To remove the drive belt:
1. Remove the
Top Cover and Front Panel.
2. Reach under the left side of the drum, push
the idler pulley to the left to take tension off the
belt.
3. Remove the belt from the motor pulley and
idler pulley. Pull the belt through the front of the
dryer.
To remove the belt switch:
1. Remove the
Top Cover, Front Panel, and Drum.
2. Disconnect the wiring to the belt switch.
3. Remove the 2 Phillips head screws that hold
the belt switch to the motor bracket.
Screw
Belt Switch
Idler Pulley
Belt
Motor Pulley
Idler Pulley
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 62 63

Comments to this Manuals

No comments