GE DPGT750EC/GC User Manual download pdf (Page 24)

– 24 –

4. Remove the 4 screws that hold the front drum

support to the sides of the dryer.

Drum

WARNING: Sharp edges may be exposed.

Wear Kevlar gloves or equivalent protection.

The dryer drum is made of 304 stainless steel

and has three replaceable drum baffles attached

to the inside. The drum rotates clockwise at 47 to

50 rpm.

To remove the drum:

1. Remove the

Top Cover and the Front Panel.

2. The heat shield is held in place by 4 Phillips

head screws (2 on each side) and 2 plastic

rails (1 on each side). Remove the screws

that hold the plastic rails in place. Slide the

rails forward and out.

Tech Tip: The drum can be removed without

removing the heat shield if desired. However,

installation and removal of the dum can be difficult

due to the limited space around the drum if the

heat shield is left in place.

3. Disconnect wiring to the drum light and

sensor rods.

5. Grasp the top outside edges of the front drum

support and unsnap the 4 corners from the

from the sides of the dryer. Remove the front

drum support.

6. Remove the

Drive Belt from the motor.

7. Using the belt as a handle, pull the drum

forward and guide it out of the dryer cabinet.

Rail

Disconnect Drum Light

Disconnect Sensor Rods

Front Drum Support

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 62 63

No comments

GE DPGT750EC/GC User Manual Page 24