Ge WBVH6240 User Manual Page 54

  • Download
  • Add to my manuals
  • Print
  • Page
    / 61
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 53
– 54 –
Error Code Description Problem Possible Cause/Action
E43
DC Fault -
Inverter
Inverter failure.
Non-recoverable error.
Replace inverter control board.
E45 Drive motor -
overload current
Load too
heavy.
Check Motor - t10 tumble, t11 spin, T14 spin.
Check mechanical faults - check belt, basket,
bearing - rotate basket by hand.
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.)
E46 Drive motor -
over temperature
Inverter over
temperature.
Check Motor - t10 tumble, t11 spin, T14 spin.
Power down (unplug) washer, wait 30 seconds and
retry - use whites cycle sanitize temperature - if
reoccurs, replace drive motor. (Note: Cannot occur
with open winding.)
E47 Heat sink - over
temperature
Inverter over
temperature.
Check Motor - t10 tumble, t11 spin, T14 spin.
Power down (unplug) washer, wait 30 seconds and
retry - use whites cycle sanitize temperature - if
reoccurs, replace drive motor. (Note: Cannot occur
with open winding.)
E48 Drive motor
- open
Open motor
phase.
Check Motor - t10 tumble, t11 spin, T14 spin.
Check motor for open winding - if OK, replace
inverter. (Note: Occurs with open winding.)
E49 Drive motor -
overload power
Load too
heavy.
Check Motor - t10 tumble, t11 spin, T14 spin.
Check mechanical faults (binding) - belt, basket,
bearing - rotate basket by hand.
Check motor for shorted winding - if OK, replace
inverter.
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.
E4A Under volts Under volts -
DC bus voltage
(inverter).
Check Motor - t10 tumble, t11 spin, T14 spin.
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.)
E4B Power up
problems
Software/
hardware
problems.
Check Motor - t10 tumble, t11 spin, T14 spin.
Check motor windings - internal short
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.)
E4C Over volts Over volts - DC
bus (inverter).
Check Motor - t10 tumble, t11 spin, t14 spin.
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.)
(Continued Next Page)
Page view 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 60 61

Comments to this Manuals

No comments