Ge WBVH6240 User Manual download pdf (Page 18)

– 18 –

Operation Overview

Basic Wash Cycle

Note: See Component Locator Views for identiﬁ cation

and location of washer components.

After a load is placed in the wash basket, the user

opens the dispenser drawer and positions the

detergent selector for the type of detergent to be

used.

Detergent is added to the detergent compartment.

Detergent is added to the prewash compartment

only if prewash cycle is selected.

Note: The prewash compartment is only ﬂ ushed

with water when the PRE WASH option is selected

on the control.

If desired, add a measured amount (1/3 cup or less)

of bleach into the bleach compartment.

If desired, add the recommended amount of fabric

softener in the fabric softener compartment and

dilute with water to the maximum ﬁ ll line.

After adding laundry products, slowly close the

dispenser drawer.

The user presses the POWER button to activate the

display. If the display is active, press POWER button

to put washer into standby mode.

Rotate the cycle knob to the desired wash setting.

When selecting Whites, Colors/Normal, Active Wear,

or Delicates cycles, the following control default

settings can be changed:

EXTRA RINSE

PRE WASH

SOIL LEVEL

SPIN SPEED

WASH TEMP

Select EXTRA RINSE and PRE WASH options. Use the

SIGNAL button to change the volume level of the

end of cycle signal.

Select the SOIL LEVEL to increase or decrease wash

time needed to remove different amounts of soil.

•

Select the SPIN SPEED to change the ﬁ nal spin speed

of the cycles. Follow the fabric manufacturer's care

label when selecting spin speed.

Select the WASH TEMP to adjust the proper water

temperature for the wash cycle. Follow the fabric

manufacturer's care label when selecting wash

temperature.

Press START/PAUSE to start the wash cycle. Each

time the washer starts, a wake up routine is

initiated:

The door locks.

The wash basket brieﬂ y tumbles in both

directions.

The door unlocks.

The door locks.

The ﬁ ll cycle begins.

Water Fill

The washer automatically ﬁ lls before tumbling, and

maintains the proper ﬁ ll level using a programmed

adaptive ﬁ ll. The machine will not tumble while

ﬁ lling.

Wash Water Temperature

The ﬁ rst 10 seconds of ﬁ ll is tap cold water only. If

needed, the control board will cycle the water valves

(water tempering) to achieve the target wash water

temperature selected. Water tempering only occurs

during the main wash cycle.

Tap Cold:

Cold water valve energized.

Tap cold never involves water tempering.

Water temperature determined by supply

temperature.

All ﬁ lls except main wash are tap cold.

•

(Continued Next Page)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 60 61

Comments to this Manuals

No comments

Ge WBVH6240 User Manual Page 18

Comments to this Manuals

Related products and manuals for Washers Ge WBVH6240