Ge WBVH6240 User Manual download pdf (Page 35)

– 35 –

To remove the water valve:

Disconnect the 2 blue wires and the orange wire

from the cold water (C) solenoid.

Disconnect the 2 blue wires and the brown wire

from the hot water (H) solenoid.

Disconnect the valve outlet hose:

Note: The valve outlet hose is difﬁ cult to remove.

a. Squeeze the clamp and slide it back.

b. Carefully break the hose loose by inserting a

small ﬂ at-blade screwdriver under the hose

to break the seal.

c. Remove the hose.

Cold Water

Hot Water

Outlet Hose

Move the valve horizontally to the right. 5.

Remove the single (6-mm) hex-head screw that

holds the valve to the cabinet.

Pump

The pump consists of a 120 VAC, 60-Hz motor,

impeller, impeller housing, and a removable strainer

that helps prevent foreign objects from entering the

pump impeller and drain outlet.

The pump runs whenever the washer is in the

spin function of a cycle.

The pump runs if the water level control

overﬂ ow switch is closed and the washer is

plugged in. (Overﬂ ow protection)

The pump is capable of eliminating 17 gallons

(64 liters) per minute.

Recommended minimum standpipe diameter is

inches.

Standpipe maximum height is 96 inches,

measured from the ﬂ oor at the washer location.

The pump motor has an approximate resistance

value of 10.6 Ω.

Operation of the pump can be checked by using

service test mode t05. (See Service Test Mode.)

Speciﬁ c failures associated with the pump can

initiate error codes E30 and E31. (See Service Test

Mode.)

•

(Continued Next Page)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 60 61

Comments to this Manuals

No comments

Ge WBVH6240 User Manual Page 35

Comments to this Manuals

Related products and manuals for Washers Ge WBVH6240