GE CC-SCSTAT User Manual download pdf (Page 34)

SmartCommand Thermostat

Installation Manual

RS485 protocol

The thermostat has a robust serial protocol. It is based on a simple ASCII message format as described in the

Serial Communications Protocol manual, DCN: 150-00225.

Note: Not all of the commands/variables defined in the protocol document are applicable to the SmartCommand thermostat,

check Section 8 of the protocol manual for details.

Thermostat network commands

Serial commands received by the control unit can set a new setpoint or a new mode and when received, they

are sent to the WDU to update its display.

The thermostat also responds to request for status by serial commands and can provide all thermostat data and

setup information as well as the current revisions of the WDU and controller firmware.

The following thermostat information can be sent or requested from the thermostat by the serial protocol:

•Temperature

• Heating setpoint

• Cooling setpoint

• System mode

•Fan mode

•F/C mode

• HVAC output status

• Network address

• Any system variable

• System firmware revisions

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

No comments

GE CC-SCSTAT User Manual Page 34