GE CC-SCSTAT User Manual download pdf (Page 8)

SmartCommand Thermostat

Installation Manual

Thermostat control screen

The Thermostat control screen (Figure 2) is the default display screen normally displayed on the WDU.

Figure 2. Thermostat control screen

Temperature display

The WDU will normally display the current temperature from the internal digital temperature sensor or a

remote sensor. The sensors have an accuracy of ± 1°F (± 0.5°C). The WDU will display temperatures from -40

to 190°F (-40 to 88°C). If averaging remote sensors are attached, the display will show the average temperature

of all attached averaging sensors.

Setpoint display

The heating and cooling setpoints are displayed next to the Up and Down buttons. In heat mode, the Up and

Down buttons change the heat setpoint. In cool mode, they change the cooling setpoint. When in auto mode,

the buttons change the last call’s heating or cooling setpoint. The setpoints will push each other if they are

adjusted to within the minimum heat/cool separation (delta T) setting. This setting is default set to 4 degrees,

but can be changed in the installer settings.

Clock display

The current time is displayed in the upper left corner of the main screen. Set the clock from the User settings

screen on page 12.

MODE

FAN

76 H

Econ

s Off

Run

No Msg

10:25 AM

Outside 60

RUN

74 C

Clock

display

Setpoint

Display

Down

Fan

Run/Hold

LED

Display

Mode

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

No comments

GE CC-SCSTAT User Manual Page 8