GE JGBP38 User Manual download pdf (Page 43)

2. Locate the outside edge of the device 2

⁄

″

toward the center of the range from the marked

edge of the range.

3. Using the device as a template, mark the

position of the hole for the screw.

4. For wood construction, drill a pilot hole at an

angle of 20 degrees from the horizontal. A nail

or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw

provided.

For cement or concrete construction, you

will need a 1/4″ x 1

⁄

″ lag bolt and a 1/2″ O.D.

sleeve anchor, which are not provided. Drill

the recommended size hole for the hardware.

Install the sleeve anchor into the drilled hole

and then install the lag bolt through the device.

The bolts must be properly tightened as

recommended for the hardware.

5. Slide the range against the wall, and check

for proper installation by grasping the front edge

of the cooktop and carefully attempting to tilt the

range forward.

WHEN ALL HOOKUPS ARE COMPLETED:

MAKE SURE ALL CONTROLS ARE LEFT IN THE

OFF POSITION.

MAKE SURE THE FLOW OF COMBUSTION AND

VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.

INSTALLING THE ANTI-TIP DEVICE

1. Mark the wall where the RIGHT EDGE of the

range is to be located. Be sure to allow for the

countertop overhang if you intend to install the

range next to cabinets.

WARNING:

• Range MUST be secured with an

approved Anti-Tip device.

• Unless properly installed, the range could

be tipped by you or a child standing, sitting

or leaning on an open door.

• After installing the Anti-Tip device, verify

that it is in place by carefully attempting to

tilt the range forward.

• This range has been designed to meet all

recognized industry tip standards for all

normal conditions.

• The use of this device does not preclude

tipping of the range when not properly

installed.

• If the Anti-Tip device supplied with the

range does not fit this application, use the

universal Anti-Tip device WB02X7909.

LEVELING THE RANGE

1. Remove the storage

drawer or kick panel.

2. Use a 3/16″ open-end

or socket wrench to back

out both rear leveling legs

approximately two turns.

3. Use a 1

⁄

″ open-end or

adjustable wrench to back

out the front leveling legs

two turns.

4. Install the oven shelves

in the oven and position

the range where it will be

installed.

5. Check for levelness by placing a spirit level or

a cup, partially filled with water, on one of the

oven racks. If using a spirit level, take two

readings—with the level placed diagonally first

in one direction and then the other.

6. Adjust the leveling legs until the range is level.

7. After the range is level, slide the range

away from the wall so that the Anti-Tip device

can be installed.

Marked Edge

of Range

Approx.

Slotted

Head

Screw

Anti-Tip

Device

Wallplate

Wood Screw

Wallplate

Anti-Tip

Device

Back of

Range

Wallboard

20°

⁄

″

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 55 56

Comments to this Manuals

No comments

GE JGBP38 User Manual Page 43

Comments to this Manuals

Related products and manuals for Stoves GE JGBP38