GE JGBP38 User Manual download pdf (Page 44)

CONVERTING TO LP GAS (Sealed Burner models only)

or Converting Back to Natural Gas from LP

HOW TO CONVERT A SEALED BURNER RANGE

FOR USE WITH LP GAS OR NATURAL GAS

This range leaves the factory set for use with natural

gas. If you convert to LP gas, keep these instructions

and orifices in case you want to convert back to

natural gas.

The conversion should be done by a qualified

technician or installer.

TOOLS REQUIRED:

Adjustable wrench

1/2″ open-end wrench

Flat blade screwdriver (small)

Nut drivers: 9/32″ or 7mm

PREPARE RANGE FOR CONVERSION

(1) Turn off gas supply at the wall.

(2) Turn off the electrical power to the range.

If range has not yet been connected to gas supply,

or if flexible connection was made, range may be

pulled out from the wall to make conversion

easier.

CONVERT THE PRESSURE REGULATOR

1. Remove the storage drawer or kick panel

and locate the pressure regulator at rear of

the range.

On some models, you may have to remove an

access cover also.

2. Follow the directions in box or that

match your regulator type.

WARNING: Do not remove the pressure

regulator from the range.

Remove Screws

Access Cover

If It Is This Regulator:

1. Use an adjustable wrench to remove the

nut from the pressure regulator.

2. Apply sideward finger pressure to remove

the plastic pin from the nut.

HINT: To remove the pin, place the nut on

a flat surface and press the pin sideways with

your fingers.

3. Push down on the disc edges to replace the

pin in the nut.

4. Reinsert the assembly into the regulator.

If It Is This Regulator:

1. Unscrew the plastic-protected hex-nut

cap from the regulator.

2. Carefully pry the protective plastic cap off

the threaded metal cap. Gently pull the plastic

washer off the threads on the other side of the

metal cap.

3. Push the plastic cap onto the end of the metal

cap displaying the type of gas you are converting

to. Press the attached plastic washer onto the

threads on the other side of the metal cap.

4. Screw the hex-nut cap back into the regulator.

Do not overtighten.

Gas Flow

into Range

NAT

Lever shown

closed. PULL

TO OPEN.

Converter

nut and pin

NAT

Gas Flow

into Range

NAT

Cap

Assembly

Do not

remove this

protective

cap except

for conversion

Lever shown closed.

PULL TO OPEN.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 55 56

Comments to this Manuals

No comments

GE JGBP38 User Manual Page 44

Comments to this Manuals

Related products and manuals for Stoves GE JGBP38