Ge 45631 GE Z-Wave Wireless Keypad Controller User Manual download pdf (Page 14)

1. Put the primary controller into device delete mode so that

it can communicate with this secondary controller. Refer to

the instruction manual for your primary controller on how to

put it into this mode

2. Press and hold Add and Remove buttons at the same time

until the Orange LED blinks twice, then release.

3. Press and release the On (up arrow) side of the fourth

(bottom) Group/Scene button.

Restoring Factory Defaults

This device can be reset to its factory default settings. This deletes

all control network programming stored in the device.

1. Press and hold both the left side (OFF) of the #1 Group/Scene

button (upper left) and the “Remove” button until the Green

LED blinks twice (approximately 3 to 6 seconds depending on

the number of nodes in the network).

Functional Overview

This device is based on the Z-Wave Controller Library and the

Remote Controller Generic Device Class. It works with devices that

support the following Z-Wave Command Classes:

1. Basic Command Class.

2. Binary Switch Command Class.

3. Controller Replication Command Class.

4. Multi-level Switch Version 1 Command Class.

When using the Basic Command Class to control devices the

controller will either transmit a value of 0 or 99, depending on

the button Pressed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Ge 45631 GE Z-Wave Wireless Keypad Controller User Manual Page 14