Ge 45631 GE Z-Wave Wireless Keypad Controller User Manual

Wireless Lighting ControlKeypad Controller45631Z-Wave® Certified Wireless Lighting Control

The network information copied to this device depends upon the brand/type of primary controller you are using. If the primary controller is a GE bran

2. Press and release the Add button.3. Press and release the Group button.4. Press and release the right side (ON) of the Group/Scene button (1, 2,

NOTE: Non-dimmable On/Off only lighting devices can be added to Scenes in either On or Off mode so as an example, the same light could be ON in Scene

2. Turn the Group or Scene ON by Pressing and releasing the right side of the desired button. The amber LED will blink twice. a. When activating

1. Put the primary controller into device delete mode so that it can communicate with this secondary controller. Refer to the instruction manual for

Keeping the controller awake:In order to extend battery life, the controller normally goes into stand-by mode (sleep) after approximately 10 seconds o

FCC NOTICEThis device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harm

Compliance with IC Rules and Regulations IC: 6924A-ZW5301Jasco Products CompanyModel: 45631 / ZW5301Object is subject to the following two conditions.

WARRANTYJASCO Products warrants this product to be free from manufacturing defects for a period of two years from the original date of consumer purcha

Introduction:Thank you for your purchase of a GE Z-Wave® control device. Z-Wave technology is designed to automate lighting/home control and provide

is a registered trademark of General Electric Company and is used under license to Jasco Products Company LLC, 10 E Memorial Rd., Oklahoma

Multi-color LED (Green/Orange/Red) (behind bezel). Visible only when the device is in setup modeAmber LEDs behind buttons provide visual feedbackTurn

Z-WAVE TERMINOLOGYPrimary Controller: This is the main device used to set up and control your Z-Wave network. There can only be one primary controller

Scene: Scenes are normally activity based lighting schemes. A Scene lets you establish preset brightness levels for multiple Z-Wave controlled lights

2. Remove the small screw from the battery retainer door. Pull out on the top of the door (it is hinged at the bottom).3. Slide the batteries out of t

RISK OF FIRERISK OF ELECTRICAL SHOCKRISK OF BURNSWARNINGControlling Appliances:Exercise extreme caution when using Z-Wave devices to control appliance

Effects of Home Construction on Wireless Range Between Z-Wave Enabled Devices.Note: The distances shown in the table below are typical examples. Actu

Please Note: Z-Wave home control networks are designed to work properly alongside 802.11 wireless computer networks, Bluetooth and other 2.4GHz or 5.