45132ChoiceALERTChoiceALERT™Control all Sensors & accessories from one location™Wireless Alarm SystemMotion SensorUser’s Manual
1011However, you can check the Motion Sensor status independently by placing the Control Center in Test mode (see Testing a Sensor on page 7) and trig
1011WARNING!Risk of personal injury- Prolonged exposure to alarm siren may cause permanent hearing lossBattery Warning!- Remove batteries before s
1213Motion Sensor F.A.Q.’SQ. I bought a new Sensor and the Control Center will not recognize it. Why?A. First, make sure that the battery is new and
1213Sensor.This will cause low battery indication on the Control Center (See pg 10).Q. Why does one of my Zones continually flash?A. This can be caus
1415FCC WarningAny unauthorized changes or modifications to the equipment would void the user’s warranty and may conflict with both state and federal la
1415WARNINGLimitations of Alarm ProductsThis product should be tested periodically to make sure it is working properly. The product, if used properly,
is a trademark of the General Electric Company and is used under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, O
23Important Safeguards 4Introduction 5Assigning a Sensor to a Zone 6-7Testing a Sensor or your system 7-8Installation 8Erasing a Se
23Before connecting or operating the Motion Sensor, please read these instructions carefully and save this manual for future reference.Congratulations
45Important safeguardsPreCautions1. Do not attempt to disassemble the Motion Sensor, unless described in the user’s manual. There are no user servicea
45IntroductionThe Motion Sensor is designed to be used indoors or out. When mounted properly it can monitor large or open areas such as entrances, liv
67Preparing the Motion Sensor for InstallationThe Motion Sensor consists of 2 parts – The Sensor (Transmitter) and the wall mount. Before installing,
67 - To activate the Motion Sensor, press the Learn button located inside the battery compartment, or if mounted wave your hand in front
89 Step 3 - Set the Notification Mode to switch ‘Alert’ position and begin activating Sensors one at a time. Note: The sensor has a LED that flashes
89Erasing the Sensor from a ZoneNote: If you need to remove the Sensor from a Zone, the system will erase the entire Zone, so any other Sensors will n
Comments to this Manuals