Ge 45132 GE Choice Alert Motion Sensor User Manual download pdf (Page 13)

Sensor.This will cause low battery indication on the

Control Center (See pg 10).

Q. Why does one of my Zones continually ﬂash?

A. This can be caused by 1 of 2 conditions. First

condition, if it is a rapid ﬂash it means a Sensor in the

Zone has a low battery. If more than one Sensor is in a

Zone, you will need to test each Sensor by putting the

unit into test mode (see pg. 9 of this manual). It may

also be that a Sensor is out of range and cannot make

contact with the Control Center. If this is the case, you

may need to move the Control Center closer or use a

Signal Repeater. The second condition, if it is a slow

ﬂash, one of the Sensors is triggered. Check to ensure

the Sensors in the Zone are closed/reset (i.e. close door,

window, etc).

Q. If one Sensor has a low battery, should I replace all

of the batteries?

A. If Sensors were added at the same time, chances

are good all the batteries will need to be replaced.

Motion Sensors battery life is less than the other

Sensors, try replacing the Sensors battery ﬁrst.

Q. How do I know if any Sensors have low batteries?

A. The Control Center will indicate if any Sensor does

not have sufﬁcient power to transmit a status signal

(battery is low). You can also check each Sensor

independently by using the Test Mode (see pg.9 in manual).

Q. If one Sensor has a low battery, will the other

Sensors in the Zone (or other Zones) continue to

operate?

A. Yes, as long as the other Sensors have sufﬁcient

battery power, they will continue to transmit

information to the Control Center and the system will

operate normally.

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Ge 45132 GE Choice Alert Motion Sensor User Manual Page 13