Ge 1000 User Manual download pdf (Page 31)

Security Pro 1000 25

Testing Communication

Communication between your system, the central monitoring station and your pager

should be tested at least once per week to make sure you have the proper telephone

connection.

¾

To perform a phone test:

1. Open the panel cover.

2. Enter the master access code.

3. Press the Test button twice. The panel will announce Phone test, press again to

change or done to select.

4. Press the DONE button.

Note

If your system is not con-

nected to a central monitor-

ing station and you don’t use

a pager, you won’t be able to

perform the phone test.

The panel will announce Phone test is on at least twice. If the test is successful the

panel will announce Phone test ok within 3 minutes. The panel will announce Phone

test is on three times if you have a pager. If the phone test to the pager was successful,

your pager will display -101-101. If the test is unsuccessful, the SYSTEM STATUS

button will light and within 10 minutes the panel will announce Phone communication

failure. If a phone test fails, call your security system dealer.

Setting the Clock

If the panel loses power, the clock must be set. The default setting is 12 hour mode.

Your installer can set the clock to 24 hour mode if you wish.

1. Open the panel cover. Panel announces, Use numbered keys to enter ID.

2. Enter the master access code. Panel announces, Please select from Start Menu.

3. Press Clock Set from the Start Menu. Panel announces, Time is ****, to change

press hours and minutes, then press done.

4. Follow the arrow from the Clock Set button to the Hours keys.

5. Press the Hours +/

– keys and listen to the voice prompts. Stop when panel voice

announces the correct hour.

6. Press the Minutes +/

– keys and listen to the voice prompts. Stop when the panel

announces the correct minutes.

7. Press Done. The panel will announce the set time.

8. Close the cover.

Alarm System

Limitations

Not even the most advanced alarm system can guarantee protection against burglary,

fire, or environmental problems.

All alarm systems are subject to possible compromise or failure-to-warn for a variety

of reasons.

Shock Sensor Tap the glass twice, away from the sensor. Wait at least

30 seconds before testing again.

Smoke Sensor Press and hold the test button until the system sounds

transmission beeps.

Wireless Panic Button Press and hold the appropriate panic button(s) for 3

seconds.

Keychain Touchpad Press and hold LOCK and UNLOCK simultaneously for

3 seconds.

Remote Handheld Touch-

pad

Press and hold the 2 EMERGENCY buttons simulta-

neously for 3 seconds.

2-Way RF Touchpad Press and hold the 2 EMERGENCY buttons simulta-

neously for 3 seconds.

RF Electronic Thermostat No trip needed.

Device Do This

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Ge 1000 User Manual Page 31

Comments to this Manuals

Related products and manuals for Safety Ge 1000