Ge 1000 User Manual download pdf (Page 14)

Security Pro 1000

How Your

System

Communicates

to You

Your system responds to you through the use of panel voice messages, status beeps,

alarms, panel indicator lights, and to a numeric pager if programmed.

Panel Voice Messages

When you press the buttons on the panel or the touchpads, the panel responds with

voice messages. Panel voice can be enabled or disabled (see “Options”).

Note

The panel will not give voice

messages during an AVM

session. Talk to your security

system dealer to see if your

panel has the AVM option.

These messages may respond with system information or prompt you to take further

action. For example, if you want to disarm the system and you press the DISARM but-

ton, the panel responds by announcing, “Please enter your access code.”

If you press a button and the feature has not been programmed, the panel voice will

respond with “Function not available.” An example of this would be pressing CHIME

Special Motion button when you have no motion sensors in your system.

Status Beeps

Note

You may receive a different

number of status beeps if

buttons are pressed quickly

Status beeps are used to indicate key presses, status, and problems with the system.

They can be enabled or disabled (see “Options”). The following table describes status

beep activity.

Alarm Sirens and Lamp Modules

Exterior and interior sirens make 3 different alarm sounds on the premises, each indicat-

ing a different type of alarm. Sirens are programmed by the installer to time-out and

stop sounding after a specified time.

Use the following table to understand the siren sounds used by the security system.

Temporal 3 refers to a continuous pattern of 3 siren pulses then off for 1.5 seconds, 3

siren pulses then off for 1.5 seconds.

Status Beeps

Activity Beep Response

ARM Doors & Windows Exit delay and Entry delay beeps sound 2 times

every 5 seconds and 2 times per second during

the last 10 seconds (if Silent Exit is used, the Exit

delay beeps will only sound twice when you arm

and twice when the Exit delay expires)

ARM Motion Sensors Exit delay and Entry delay beeps sound 3 times

every 5 seconds and 3 times per second during

the last 10 seconds (if Silent Exit is used, the Exit

delay beeps will only sound 3 times when you arm

and 3 times when the Exit delay expires)

ARM Doors/Windows &

Motion Sensors

Exit delay and Entry delay beeps sound 4 times

every 5 seconds and 4 times per second during

the last 10 seconds (if Silent Exit is used, the Exit

delay beeps will only sound 4 times when you arm

and 4 times when the Exit delay expires)

DISARM 1 beep

CHIME DOORS 2 beeps (feature must be programmed by installer)

CHIME SPECIAL MOTION 3 beeps (feature must be programmed by installer)

Trouble Beeps 6 beeps every minute. Press the SYSTEM STA-

TUS button to stop beeps for 4 hours

No Activity Beeps 20 beeps every minute for 5 minutes (feature must

be programmed by the installer)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments

Ge 1000 User Manual Page 14

Comments to this Manuals

Related products and manuals for Safety Ge 1000