GE GXCF05D User Manual download pdf (Page 5)

Care and cleaning of the dispenser.

IMPORTANT: Set both power switches (on the

back of the dispenser) in the 0 (off) position and

unplug the water dispenser before cleaning.

The inside and outside of the cabinet can

be washed with mild soap and water. Rinse

thoroughly with clear water. Never use

commercial cleaners or abrasive scouring

powders.

Sweep away or vacuum any dust from the

condenser coils on the back of the unit. For

best results, use a brush specially designed for

this purpose. It is available at most appliance

stores.

Cleaning the Outside and Storage Cabinet (on some models)

The dispenser drip tray is not self-draining.

To reduce water spotting or deposits, the tray

and its grille should be emptied, cleaned and

wiped dry regularly.

Clean with mild soap or on the top rack in

the dishwasher.

Cleaning the Drip Tray and Grille

Drip

tray

Drip tray grille

Draining the Dispenser

The dispenser should be drained before cleaning the tanks and before leaving for long vacations or absences.

Drain outlet cap

Floor models

(rear of dispenser)

Floor Models

1. Set both power switches (on the back of the dispenser) in the

0 (off) position and unplug the dispenser.

2. Remove the water bottle from the dispenser.

3. Put a container that will withstand hot water under the hot

water tap. Press the HOT dispenser button until the water is

cool (about 1 quart). Add water to the cold water reservoir

(on top where the bottle supplies water) as needed.

4. Dispense water from both buttons into container(s) until

no more water can be dispensed (about 1 quart of water still

remains in the dispenser).

5. Place a large bucket beneath the drain outlet on the rear of

the dispenser.

6. Using a Phillips screwdriver, loosen the screws on the bracket

covering the drain outlet cap. Rotate the bracket out of the way

to allow access to the cap.

7. Remove the cap and silicon stopper from the drain outlet and

and allow water to drain. After draining, replace the stopper

and cap.

8. Rotate the bracket back into place and tighten screws.

Make sure to install a full bottle and dispense water from the

hot water tap before plugging in and turning on the dispenser

(see Loading the Dispenser).

Countertop Models

1. Set both power switches (on the back of the dispenser) in the

0 (off) position and unplug the dispenser.

2. Remove the water bottle from the dispenser.

3. Put a container that will withstand hot water under the hot

water tap. Press the HOT dispenser button until the water is

cool (about 1 quart). Add water to the cold water reservoir

(on top where the bottle supplies water) as needed.

4. Dispense water from both buttons into container(s) until

no more water can be dispensed (about 1 quart of water still

remains in the dispenser).

WARNING: Lift the dispenser carefully; it weighs

approximately 40 lbs (18 kg). Avoid accidentally pressing the

dispenser buttons while lifting or carrying.

5. Place the dispenser over a sink with 3 feet on the counter.

Hold or secure the dispenser steady while removing the

retaining clip and drain cover. Remove the retaining clip and

drain cover from the drain outlet, making sure not to damage

the drain cover. Allow water to drain.

6. After draining, replace the drain cover and retaining clip.

Make sure to install a full bottle and dispense water from the

hot water tap before plugging in and turning on the dispenser

(see Loading the Dispenser).

Drain cover and

retaining clip

Countertop models

(bottom of dispenser)

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

GE GXCF05D User Manual Page 5

Comments to this Manuals

Related products and manuals for Water dispensers GE GXCF05D