GE V6 User Manual download pdf (Page 247)

Secure Perfect 6.1.1 User Manual 245

Setting Up an Elevator

Do not switch between floor tracking and no floor tracking in the same elevator record. If you want to

change an existing record, delete that record and create a new one with the desired floor tracking

method.

1. Decide which method of elevator control you want to use: no floor tracking, floor tracking by input, or

floor tracking by keypad.

2. Set up a micro (along with the reader board(s) and the digital output board(s); if using the floor tracking

by input method, then also set up a digital input board).

• See information for setting up a direct-connect micro

• See information for setting up a dial-up micro

3. Set the desired readers to active using the Reader Tab of the Reader Form.

• See information for the Reader Tab, Reader Form.

4. Verify that the desired digital outputs are set up correctly. Also check the digital input setup if you are

using the floor tracking by input method.

5. Set up the floor descriptions using the Floor tab of the Floor Form.

6. Set up the elevator using the Elevator Form. Here you assign readers, digital outputs, and digital inputs

if using the floor tracking by input method.

Elevator control does not span micros. This means the reader, digital outputs, and digital inputs (if

applicable) MUST be on the same micro.

Settings Tab

Reference Topic:

Overview - Diagnostics

Diagnostic Setting Form

Enable debug messages: Select this box to enable monitoring for the selected diagnostic object.

Logfiles: Default and newly created LogFile names display in the Logfiles windowpane. Select a file

name from the list of files displayed, to which you are assigning this component for monitoring. By

assigning a component object to write to a particular logfile, you are removing that object from the list of

components that will write to the default logfile.

Save your new settings.

When you open the Diagnostic Viewer, the activities of your selected component will display in the logfile

to which it is assigned. (Those items with the COM # and Line # as part of the component name have the

highest effect on system performance and hard drive usage.)

After viewing, return to the Diagnostic Setting Form and disable the debug messages.

1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 268 269

No comments

GE V6 User Manual Page 247