GE GSD4210 User Manual download pdf (Page 19)

Customer ServiceTroubleshooting TipsOperating InstructionsSafety Information

Problem Possible Causes What To Do

Water standing in

This is normal • A small amount of clean

the bottom of the tub

water around the outlet on

the tub bottom at the back

of the tub keeps the water

seal lubricated.

Water won’t pump

Drain is clogged • If you have an air gap,

out of the tub

clean it.

• Check to see if your kitchen

sink is draining well. If not,

you may need a plumber.

• If the dishwasher drains

into a disposer, run

disposer clear.

Suds in the tub

Correct detergent • Use only automatic

wasn’t used dishwasher detergents to

avoid sudsing.

• To remove suds from the

tub, open the dishwasher

and let suds evaporate.

Add 1 gallon of cold water

to the tub. Close and latch

the dishwasher. Pump out

water. Touch

START,

then

immediately touch

RESET.

Repeat if necessary.

Rinse agent • Always wipe up rinse agent

was spilled spills immediately.

Steam

This is normal • Steam comes through the

vent by the door latch

during drying and when

water is being pumped out.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

GE GSD4210 User Manual Page 19