Ge GXSL03C User Manual download pdf (Page 8)

Electronic Faucet Installation for Model GXSV10C

Be sure there is room underneath the sink to make the needed connections.

Select one of the following places to install the faucet:

—IN an existing sink spray attachment or soap dispenser hole.

—IN a hole to be drilled in the sink top.

—IN a hole to be drilled in the countertop, next to the sink.

NOTE: Looking at fourth illustration at right, be sure the faucet base will

fit flat against the surface at the selected location so the gasket will seal.

The base may have to be angled sideways or diagonally.

If drilling is needed, make a 1″–1 1 ⁄ 4 ″ dia. hole. Be

sure to use the

proper procedure for drilling porcelain or stainless steel. Special drill bits

may be needed.

Looking at first illustration, insert a screw into the NON-SLOTTED

base mounting hole. Turn a flat nut a few turns onto the screw.

Position the base gasket over the mounting hole. Set the base on the

gasket, routing the leadwire through the mounting hole. Holding the

flat nut under the sink with one finger, tighten the screw until just snug.

Turn the remaining flat nut a few turns onto the other screw. Position

the screw in the slotted base mounting hole and tighten until snug.

Make sure the gasket position is properly aligned and carefully tighten

both screws until the base is held firmly in place. Do not overtighten

and break the base.

Assemble the top faucet base and hex nut onto the faucet stud

(third illustration). Tighten the nut until snug.

Insert tubing insert into tubing adapter. Securely tighten to faucet stud.

Feed the length of 3/8″ OD tubing from the bottom up through the

faucet base. Connect to the tubing adapter as shown in fourth illustration,

tightening the compression nut securely.

Remove the short shipping tube and screw the spout into the faucet body.

Lower the faucet assembly and lock into place on the faucet base.

Faucet

base

Nut (2)

Screw (2)

1″–1 1/4″ dia.

mounting hole

in sink or

countertop

Gasket

Faucet base

TOP VIEW

Screw (2)

Nut (2)

Tubing insert

Hex nut

Top faucet base

Faucet

Lever

Spout

Faucet stud

ASSEMBLED

Step-by-step installation instructions.

Battery Pack Installation and Connection

In a dry location, within reach of the electronic base 3′ lead wire, select a

place for the battery pack (see illustration on page 5). The battery pack

attaches to most surfaces, using the included “sticky-back” Velcro

™

strip.

The battery pack uses two size AA batteries. Check to be sure they are

installed correctly. Then, remove the paper backing on the Velcro

™

strip

and secure the pack in place.

Fasten electronic base lead wire and battery pack connector together.

Base lead wire connector

(to battery pack)

3/8″ tubing, (run

to Filter 2 outlet)

Faucet base

Compression nut

Tubing insert

Tubing adapter

Compression nut

Tubing adapter

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comments to this Manuals

No comments

Ge GXSL03C User Manual Page 8

Comments to this Manuals

Related products and manuals for Water equipment Ge GXSL03C