GE EL Series Installation Guide download pdf

Lighting

Installation Guide

imagination at work

(EL Series – Cable Suspension Remote Driver)

Lumination

™

Linear Suspended LED Luminaire

BEFORE YOU BEGIN

Read these instructions completely and carefully.

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL approved wire for input/output connections.

Minimum size 18 AWG (0.82 mm

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL pour les entrées/sorties de

connexion. Taille minimum 18 AWG (0.82 mm

Save These Instructions

Use only in the manner intended by the manufacturer.

If you have any questions, contact the manufacturer.

Important

Wear work gloves to prevent dirt and oil from being

transferred to the luminaire.

Tools and Components Required

• #2 Philips head screwdriver

• UL Recognized conduit connections per NEC/CEC for nominal

conduit trade sizes 1⁄2” or 3⁄4”

• UL Recognized wire connectors

CAUTION

RISK OF DAMAGE:

• Luminaire may fall down if not installed properly

• Remove protective lm on Light Guide only after installation

• Do not touch Light Guide to avoid dirt, oil and ngerprints

Prepare Electrical Wiring

Electrical Requirements

• The LED driver must be supplied with 120-277 VAC,

50/60 Hz (in 120-277V application).

• For Series EL-DKIT36D-S-347V, the unit must be

supplied with 347 VAC, 60 Hz (in 347V application).

• Connected to an individual properly grounded

branch circuit, protected by a 15 or 20 ampere

circuit breaker. Use min. 75°C supply conductor.

Grounding Instructions

• The grounding and bonding of the overall system

shall be done in accordance with National Electric

Code (NEC) Article 600 and local codes.

1 2 3

Summary of Contents

Page 1 - Lumination

GELightingInstallation Guideimagination at work(EL Series – Cable Suspension Remote Driver)Lumination™ Linear Suspended LED LuminaireBEFORE YOU BEGINR

Page 2 - Luminaire Installation

3 4Connect the black (neutral) and red (line) wires from theluminaire to the blue (neutral) and red (line), respectively, from the driver enclosure. C

Page 3 - Inter connector

IND082-1011131Put inter connector on the top of two luminaires and make sure that the slot of the inter connector cross the two end caps.2Push the int