GE JVM2052 User Manual download pdf (Page 8)

Installation Instructions

Find the studs, using one of the following

methods:

A. Stud finder – a magnetic device which

locates nails.

B. Use a hammer to tap lightly across the

mounting surface to find a solid sound.

This will indicate a stud location.

After locating the stud(s), find the center by

probing the wall with a small nail to find the edges

of the stud. Then place a mark halfway between

the edges. The center of any adjacent studs should

be 16″ or 24″ from this mark.

Draw a line down the center of the studs.

IMPORTANT: The microwave oven must be connected

to at least one wall stud.

Remove the installation instructions, filters, glass tray

and the small hardware bag. Do not remove the

Styrofoam protecting the front of the oven.

Fold back all 4 carton flaps fully against carton sides.

Then carefully roll the oven and carton over onto the top

side. The oven should be resting in the Styrofoam.

REMOVING THE MICROWAVE

OVEN FROM THE CARTON/

REMOVING THE MOUNTING

PLATE

FINDING THE WALL STUDS

PLACEMENT OF THE MOUNTING PLATE

Wall

Studs

Center

Carton

Pull the carton up and off the oven.

Remove the 2 screws from the mounting plate. This

plate will be used as the rear wall template and for

mounting. You may discard these screws.

Mounting

Plate

Screws

Styrofoam

Remove and properly discard plastic bags.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

GE JVM2052 User Manual Page 8